• Q : Design a synchronous....
    Electrical Engineering :

    Design a synchronous, recycling, MOD-5 down counter that producesthesequence 100, 011, 010, 001, 000, and repeat. Use J-K FFs.(a) Force the unused states to 000 on the next clock pulse.(b) Use don

  • Q : Synchronous motor has an applied line voltage....
    Electrical Engineering :

    A four pole, 60Hz, 50 hp synchronous motor has an applied line voltage of 480 volts and draws 60A from the line. it is operated at a power factor of .90. the motor rotor rotates at 1800 rmp at

  • Q : Experiment on loadtest on dcshunt generator....
    Electrical Engineering :

    While doing experiment on loadtest on dcshunt generator,what happens when dc shunt generator is replaced by dc compound generator?

  • Q : This value without computing the inverse....
    Electrical Engineering :

    Use MATLAB to compute the inverse Laplace transform of X(s)=(s^2+2s+1)/(s(s+1)(s^2+10s+50)) and determine the value of x(t) in the steady state. How would you be able to obtain this value withou

  • Q : Calculate the power in each resistor....
    Electrical Engineering :

    1) Three resistors R1, R2 and R3 are connected in series and a supply voltage of 240 V. If R2 = 2R1, R3 = 3R1 and the total power taken by the circuit is 480 watts. Calculate the power in each r

  • Q : Consider the component values....
    Electrical Engineering :

    Use MultiSim (or Matlab) to calculate the output signal, V, shown in fig. 3, use eq. 2 for your calculations. Consider the component values given in 2.1. Set the frequency of the input voltage as s

  • Q : Clearly explain the computational advantages....
    Electrical Engineering :

    Clearly explain the computational advantages of applying lu factorisation when forming and storing the admittance matrix for power network calculations.

  • Q : A schottky diode and pn junction diode....
    Electrical Engineering :

    A Schottky diode and pn-junction diode have cross-sectional areasof 10-4cm2. The reverse saturation current density of the Schottky diode is 5*10-8A/cm2 and thereverse saturation current density of

  • Q : Consider a cartesian co ordinate system....
    Electrical Engineering :

    Consider a Cartesian co-ordinate system on a plane (the plane lines on the x- and y-axis). A current of 100 A is flowing up out of the plane at the origin. Find the MMF drop between the point x=

  • Q : Events on food prices in the united states....
    Electrical Engineering :

    Assume initially that the demand and supply for premium coffees (one-pound bags) are in equilibrium. Now assume Starbucks introduces the world to pre- mium blends, and so demand rises substantiall

  • Q : Introduction to computer communication networks....
    Electrical Engineering :

    What is the difference between "Introduction to Computer Communication Networks" course and computer networks course? do they have the same material?

  • Q : Attenuation due to rayleigh scattering....
    Electrical Engineering :

    Rayleigh Scattering. Calculate the % increase is attenuation due to Rayleigh scattering exhibited by light having a free-space wavelength 1535 nm as compared to light having a free space wavelen

  • Q : Distributed along a semicircular ring....
    Electrical Engineering :

    A point charge Q is located at (0,-4,0) while a 10nC charge is uniformly distributed along a semicircular ring as shown in Fig. 4.25 (semi circle in the xy plane from x= -2 to x =2, y=2) Find th

  • Q : The membrane potential typically moves....
    Electrical Engineering :

    During an AP, the membrane potential typically moves from -70mV to +20mV and back again. In a cell with 10um radius and 1uF/cm^2, how many charges need to move across the membrane (and back agai

  • Q : The largest possible diameter....
    Electrical Engineering :

    A micrometer caliper is used to measure the diameter of a bolt and a reading of 0.768 inches is obtained. Based on this measurement, find the smallest possible diameter and the largest possibl

  • Q : Determine the distribution of the number of taxis....
    Electrical Engineering :

    Assume that the passengers arrive at a taxi stand according to a Poisson process with parameter λ. There are m taxis serving to the passengers in the queue. Each taxi serves a single custo

  • Q : Investment in energy generation....
    Electrical Engineering :

    When conducting an energy audit before sizing a renewable energy system, why should efficiency measures be considered before investment in energy generation?

  • Q : How does this change the bandwidth your system require....
    Electrical Engineering :

    Suppose that you wish to offer a voice over IP wireless service. The target packet error rate (or drop rate) is 10^3 and you determine that if the signal is confined to within a coherence band, abou

  • Q : Design a combinational circuit....
    Electrical Engineering :

    Design a combinational circuit that takes two 3-bit binary numbers a2a1a0 and b2b1b0 and generates Modulo- 8 addition. Recall that the MOD operation produces the remainder value in an integer divis

  • Q : Calculate the electron....
    Electrical Engineering :

    A new semiconductor has Nc = 1019 /cm3 and Nv=5 x 1018, and Eg = 2eV. If it is doped with 1017 donors (fully ionized), calculate the electron, hole, and intrinsic carrier concentrations at 627K.

  • Q : Special effects are achieved by changing the properties....
    Electrical Engineering :

    In animation programs, special effects are achieved by changing the properties of objects. What instruction is used to change the opacity and color properties of objects in the Zeus example worl

  • Q : Specify a modulation format....
    Electrical Engineering :

    Suppose the FCC allocates 300 kHz channels for a high quality video conference service. A service provider decides that this service requires 720 kbps (not including overhead and error control) for

  • Q : What is the input resistance of the gate....
    Electrical Engineering :

    A 2n5640 has a gate current of 1uA when the reverse voltage is -20V and the ambient temperature is 100 degees C. What is the input resistance of the gate?

  • Q : Ideal ohmmeter is connected....
    Electrical Engineering :

    In the circuit shown in Figure, an ideal ohmmeter is connected across ab with the switch S open. All the connecting leads have negligible resistance. What will be the ohmmeter reading in Ohms (w

  • Q : The input of the channel....
    Electrical Engineering :

    Consider a (Nt,Nr) =(4,4) MIMO channel. For the input of the channel x = [x1,x2,x3,x4] assume that each xi is drawn from a BPSK constellation with energy P. Also assume that the channel noise va

©TutorsGlobe All rights reserved 2022-2023.