• Q : The plates of a parallel plates capacitor....
    Electrical Engineering :

    The plates of a parallel plates capacitor are 5mm apart and2m2 in area,the plates are in a vacum.a potential difference of 10000 volts is applied across the capacitor.calculate.(1)the capacitanc

  • Q : The final tailings slurry produced by the process....
    Electrical Engineering :

    In a metal processing facility, the final tailings slurry produced by the process is thicken in a caisson and thickener and pumped out of for disposal. The density of the slurry that leaves the t

  • Q : A conducting rod having a mass density....
    Electrical Engineering :

    A conducting rod having a mass density 2 kg/m is suspended by two flexible wires in a uniform magnetic field which points out of the page. a battery is also attached .if the tension on the wires

  • Q : How many bits are required to represent the decimal....
    Electrical Engineering :

    How many bits are required to represent the decimal numbers in the range from 0 to 999 using straight binary code? Using BCD code?

  • Q : An astronaut drops an object from rest....
    Electrical Engineering :

    An astronaut drops an object from rest (relative to the planet) on a planet alpha (having the same radius as of earth) from an altitude of one radius above the surface. When the object hits the

  • Q : Circuit and correct what is wrong....
    Electrical Engineering :

    I am doing a simulation using Matlab /Simulink and the circuit (based on power electronic components) is not working as it has to. Does any one can review my circuit and correct what is wrong in

  • Q : Consider a sinusoidal wave with frequency....
    Electrical Engineering :

    Consider a sinusoidal wave with frequency of 300KHz as a carrier signal. We want to transmit a sinusoidal signal with f=3KHz and Amplitude=1. Plot the AM modulated signal in MATLAB.

  • Q : Realize the storage circuits....
    Electrical Engineering :

    The block diagram for an elevator controller for a two-floor elevator follows. The inputs FB1 and FB2 are 1 when someone in the elevator presses the first or second floor buttons, respectively. Th

  • Q : The closed limb of a macleod gauge....
    Electrical Engineering :

    The closed limb of a macleod gauge has a diameter of 1mm and a value V above the level of the opening W of 250cm3. When the gauge is connected to a vacuum source the difference h in mercury leve

  • Q : Design a negative edge-triggered....
    Electrical Engineering :

    Design a negative edge-triggered D flip-flop that uses three SR latches constructed with cross-coupled NOR gates. Also connect asynchronous inputs Preset (PST) and Reset (RST). Draw the logic di

  • Q : The average source and destination....
    Electrical Engineering :

    For a 1-Gbps network operating over 5000 km, the delay is the limiting factor, not the bandwidth. Consider a Metropolitan Area Network (MAN) with the average source and destination 40 km apart. At

  • Q : What is the full load for secondary....
    Electrical Engineering :

    A 300-kilowatt-ampere transformer bank consisting of three 100-kilovolt-ampere transformer has a 3-phase, 480-volt delta primaryand a 3-phase, 208Y/120 secondary. what is the full load for primar

  • Q : A block and tackle system....
    Electrical Engineering :

    A block and tackle system with nine supporting strands is used to lift a metal lathe in a manufacturing facility. The motor being used to wind the cable in the pulley system can provide 100 lb

  • Q : A metal processing facility....
    Electrical Engineering :

    In a metal processing facility, the final tailings slurry produced by the process is thicken in a caisson and thickener and pumped out of for disposal. The density of the slurry that leaves the t

  • Q : A conducting rod having a mass density....
    Electrical Engineering :

    A conducting rod having a mass density 2 kg/m is suspended by two flexible wires in a uniform magnetic field which points out of the page. a battery is also attached .if the tension on the wires

  • Q : How many bits are required to represent....
    Electrical Engineering :

    How many bits are required to represent the decimal numbers in the range from 0 to 999 using straight binary code? Using BCD code?

  • Q : The name of the free internet browser....
    Electrical Engineering :

    The name of the free Internet browser from Mozilla is:Podcasts use which of the following technologies The text version of a Web site's Internet address is called the:All of the following are ways to

  • Q : An astronaut drops an object....
    Electrical Engineering :

    An astronaut drops an object from rest (relative to the planet) on a planet alpha (having the same radius as of earth) from an altitude of one radius above the surface. When the object hits the

  • Q : Consider a sinusoidal wave with frequency....
    Electrical Engineering :

    Consider a sinusoidal wave with frequency of 300KHz as a carrier signal. We want to transmit a sinusoidal signal with f=3KHz and Amplitude=1. Plot the AM modulated signal in MATLAB.

  • Q : The block diagram for an elevator controller....
    Electrical Engineering :

    The block diagram for an elevator controller for a two-floor elevator follows. The inputs FB1 and FB2 are 1 when someone in the elevator presses the first or second floor buttons, respectively. T

  • Q : The closed limb of a macleod gauge....
    Electrical Engineering :

    The closed limb of a macleod gauge has a diameter of 1mm and a value V above the level of the opening W of 250cm3. When the gauge is connected to a vacuum source the difference h in mercury leve

  • Q : Design a negative edge-triggered....
    Electrical Engineering :

    Design a negative edge-triggered D flip-flop that uses three SR latches constructed with cross-coupled NOR gates. Also connect asynchronous inputs Preset (PST) and Reset (RST). Draw the logic di

  • Q : What is the full load for primary....
    Electrical Engineering :

    A 300-kilowatt-ampere transformer bank consisting of three 100-kilovolt-ampere transformer has a 3-phase, 480-volt delta primaryand a 3-phase, 208Y/120 secondary. what is the full load for primar

  • Q : What data rate does the round-trip delay....
    Electrical Engineering :

    For a 1-Gbps network operating over 5000 km, the delay is the limiting factor, not the bandwidth. Consider a Metropolitan Area Network (MAN) with the average source and destination 40 km apart. At

  • Q : The mechanical advantage of the system....
    Electrical Engineering :

    A block and tackle system with nine supporting strands is used to lift a metal lathe in a manufacturing facility. The motor being used to wind the cable in the pulley system can provide 100 lb

©TutorsGlobe All rights reserved 2022-2023.