Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
Illustrate the construction and working of Chevrolet turbo glide transmission.
Sketch and illustrate the Working of Cotal gear box. Discuss the construction and working of the Ford T Model transmission with neat sketch.
Write down the advantages of Automatic Transmission. Write down the functions of the Control unit in ECT.
What do you mean by rigidity modulus? What do you mean by kinematic viscosity?
Explain D’ Alembert’s principle in detail. Describe inertia force and inertia torque.
Shaft of 100mm diameter and 1 meter long is fixed at one end and other carries a flywheel of mass one tonne. By taking Young’s modulus of shaft materials as 200GN/m2, determine the natural fre
If maximum permissible stress in belt is 2 MN/m2, determine the maximum power transmitted and initial tension in belt.
Explain inversion. Describe any three inversion of single slider mechanism, with neat and suitable sketches.
Write down the various sources of errors in measurements and measuring instruments? Describe in detail.
Write down the name of any four actuating mechanisms used in transducers.
Describe the working of Nuclear Power Plant with the suitable sketch?
Illustrate out the different types of light commercial vehicle bodies with appropriate sketches.
Write down the purpose of the conducting wind tunnel tests? Illustrate out the term vehicle drag.
Give a description of intensity of radiation. How does thermal stress influence the cylinder piston?
Write down any four properties of the good refrigerant?
Write down the difference between impulse turbine and reaction turbine.
Explain Volumetric efficiency of a compressor in detail.
Explain with simple and suitable sketches of operating features of material handling equipments given below. Write down the example of a situation for which each one is used.
Describe the working of bucket elevator with a neat and suitable sketch.
Draw a Knukle joint to transmit the load of 120 KN in tension or compression. Suppose the following allowable stresses.
What do you mean by direct shear and torsional shear?
Why I-section is preferred for connecting rod? Write down some piston materials.
Sketch and describe the Vapour Compression system. Illustrate out with the neat sketch the Evaporating system in refrigerator.
Illustrate out the concept of the Adaptable-Programmable Assembly System (APAS) involved in the assembly.
With the use of sketch illustrate the drive systems and feedback devices in components of Robots. Make a distinction contact and noncontact sensors.