Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
Using the example of a simple RC high-pass filter circuit, show how the inclusion of a coupling capacitor will limit the low frequency of any amplifier circuit
A certain op-amp has an open-loop voltage gain of 100,000 and a common mode gain of 0.2. Determine the CMRR in dB.
Twenty voice signals are to be multiplexed and transmitted over twisted pair. What is the bandwidth required (in bps) if synchronous time division.
From this the inverse z transform to find the output in the time domain due to the step input is determined.
The block diagram of a control system is given below. The inner loop is positive feedback, i.e. Ks>0,and hence the system is unstable.
Suppose the development budget is tight. How might that affect the fact-finding process?What are five important questions to use during fact-finding?
S-R flipflops have a forbidden state that makes them hard to use. Some designers switched to the following flipflop instead.
For a causal LTI system what can you say about the poles of the z transform and the boundary of the region of convergence.
The user is prompted to enter an integer between 1 and 1000. When the user enters the integer, the program uses a repetition control structure.
The forced or damped frequency of oscillation, and the natural or undamped frequency.
What are the respective advantages and disadvantages of the asynchronous and synchronous communication modes from a reliability perspective?
From a given z transform X(z) = {1- z^-10}/{1 - z^-1} the discrete time domain form x(n) is deduced using complex manipulation and inverse transforms.
A Moore sequential circuit has one input and one output.The output goes to 1 when the input sequence 111 has occurred and the output goes.
If the radio in part (e) above receives a signal with power -100.0 dBm, what is the CNR (carrier to noise ratio) in the receiver?
A 12 kHz sine wave signal with a power level -25 dBm is applied to the input of the amplifier. What is the power at the amplifier output in dBm?
If the spectrum suddenly changes to have zeroes at 5 kHz, 10 kHz, 15 kHz, etc, what is the new pulse width?
The maximum frequency of the baseband audio signal is 10 KHz and the bandwidth allocated to the FM audio signal is 100 kHz.
How are the left (L) and right (R) signals obtained separately in the radio receiver to drive the dual channel audio amplifier and speakers?
How much additional rain attenuation can occur when the link is using QPSK modulation, compared to 16-QAM?
The signal could have been sent using DSB-LC modulation. What bandwidth would be required to transmit the signal with DSB-LC?
The bit rate on the link needs to be increased to a T1 rate of 1.544 Mbps. What change must be made to the transmitted signal?
A receiver of the CDMA signal has a C/(N+I) ratio of -8.0 dB at its input. What is the CNR at the output of the correlator, assuming ideal operation?
Each burst transmission from each earth station starts with a 176 bit sequence called CBTR. What is the purpose of CBTR?
Improving the floating point ALU to one which cost 4.5 times the original and would treble the performance of the ALU.
If the SNRQ were to be raised to 96 dB, how many bits would the ADC and DAC need? What would be the bit rate on the serial link?