Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
dampingnbsp experimentsnbsp onnbsp ironnbsp werenbsp madenbsp usingnbsp anbsp torsionnbsp pendulumnbsp nbspwith a
an elastomer was suddenly stretched in tension and the elongation was held constant after 10 min the tensile stress in
the data below were taken on a test material to determine its fracture toughness the specimens were 25 mm thicka make a
a structural member is made from a steel that hasnbspkic 180 mparadicmnbspand yield strength 1050 mpa in service it
for 4340 steel the fracture toughness and yield strength depend on the prior heat treatment as shown in figure as yield
a wing panel of a supersonic aircraft is made from a titanium alloy that has yield strength 1035 mpa and
class 20 and class 60 gray cast irons have tensile strengths of about 20 and 60 ksi respectively assuming that the
using the two theoretical predictions of fracture strength anbspsigmat epinbspequation 144 and bnbspsigmat
is it safe to say that brittle fracture can be avoided in steel structures if the steel is chosen so that its charpy
it has been argued that the growth of internal voids in a material while it is being deformed is given by
for a material with a tensile yield strengthnbspy determine the ratio of the mean stress onbspm tonbspynbspat the
consider a very ductile material that begins to neck in tension at a true strain of 020 necking causes an additional
consider a material strengthened by precipitation of ne particles suppose the shear yield strength of the particles
when music wire 100 pearlite is cold drawn the pearlite spacing is reduced in proportion to the wire diameter that
when magnesium twins on the 1012 planes in thenbsp10 11gtnbspdirections what is the angle between thec-axes ie the 0001
the rolling texture of most hcp metals can be roughly described by an alignment of thenbspc-axis with the rolling plane
assume that a resolved shear stress of 14 mpa is applied to a crystal and causes dislocations to pile up at a
consider how dislocation intersections affect the stress necessary to continue slip let the density of screw
orowan showed that the shear strain rate is given bynbspgammanbsp dgamma dt nbsprhobv nbspwherenbsprhonbspis the
typical values for the dislocation density in annealed and heavily deformed copper are 107 and 1011 cm-2 for copper
consider a sheet of an fcc metal that has anbsp110nbsptexture that is anbsp110nbspplane is parallel to the plane of the
determine the number of independent slip systems for crystals with each of the following combinations of slip systems
nacl crystals slip onnbsp110nbspslip systems there are six systems of this type consider a crystal subjected to
consider an aluminum single crystal that has been stretched in tension applied parallel tonbspxnbsp 100 sigmanbspxnbsp