Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
the compressive strength of kevlar is about 18 of its tensile strength if it is bent to a small radius of curvature it
the tensile and compressive yield stresses of polystyrene are 73 and 92 mpa respectively crazing occurs at 47 mpa in
according to equations 2010 and 2011 yielding is possible under a state of pure hydrostatic tensionnbspsigmah find that
annbsp isotropicnbsp pressure-dependentnbsp yieldnbsp criterionnbsp fornbsp polymersnbsp ofnbsp thenbspnbsp
evaluate the coefcient of thermal expansionnbspalpha for rubber under an extension of 100 at 20c a rubber band was
a glass retort is to be used under the conditions that the temperature of the inside of the wall is 100c and the
rapid heating and cooling can cause cracks to start at the surface of a ceramic material sometimes the cracks meet the
1 what percent reduction of the elastic modulus of alumina would be caused by 1 porosity2 pottery is generally red at a
twenty ceramic specimens were tested to fracture the measured fracture loads innbspnnbspwere 279 195 246 302 255 262
from a large number of tests on a certain material it has been learned that 50 of them will break when loaded in
1 estimate the ratio of the elastic moduli of cubic alsb and cubic znse both have the sphalerite structure the lattice
during a stress relief anneal creep occurs which converts elastic strains and therefore stresses into plastic strains
a typical residual stress pattern in an extruded bar is shown in figure to nd the residual stresses in an extruded bar
for polycrystalline magnesium the coefcient of thermal expansion is 252 times 10-6c and youngs modulus is 684 gpa
a surface layer 0001 in thick was removed from an aluminum sheet 0015 in thick on removal of the layer the sheet curled
a 1-cm-diameter steel ball is cooled after austenitization at one point during the cooling a 05-mm-thick layer at the
consider a material composed of equal volumes having different yield strengthsnbspyb 15ya but the same elastic
the residual stresses adjacent to a long butt weld between two deck plates of a ship were found by x-rays the average
in fatigue tests on a certain steel the endurance limit was found to be 1000 mpa fornbsprnbsp 0 tensile-release
for another steel the fatigue limits are 10000 cycles at 100 ksi 50000 cycles at 75 ksi and 200000 cycles at 62 ksi if
low-cycle fatigue was the cause of the comet failures estimate how many pressurization-depressurization cycles the
for steels the endurance limit is approximately 12 of the tensile strength and the fatigue strength at 103 cycles is
stress rupture data are sometimes correlated with the dorn parameternbspthetanbspnbsptnbspexp-qrtnbsp wherenbsptnbspis
for many materials the constantnbspcnbspin the larson-miller parameternbsppnbsp tnbsp 460cnbsp log10t wherenbsptnbspis
a polymer is subjected to a cyclic stress of 5 mpa at a frequency of 1 hz for 1 min the phase angle is 005 calculate