Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
"This project is about building a coded lock system using ATmega8 by using assembler language. LCD should show your name on the first line and on the second line it should show enter code and wh
The differences between axial gap and radial gap permanent magnet motors, and between surface mounted and submerged magnet designs for a short seminar discussion I am going to have in August. Wh
A process control system will be tuned with the ultimate cycle method. The derivative mode is off, and the integral mode is set at its lowest setting. The gain is increased gradually until the P
The current flowing through a circuit is i(t)=4t+3A. How much charge passes through the circuit element between 0 and 2 seconds?Three circuit elements are joined at a node in a circuit. Two amps ar
You design a receiver for the 5.8ISM band, using the ZJL-6G+ Minicircuits. It is not correctly matched, with Z0 = 30ohm at +60 degrees. Find S11 from the data sheet at that frequency, noise figu
How would I convert Multisim a circuit that will convert that 0-10VDC signal into a 4-20mA signal for the long haul. And then convert that 4-20mA signal, back into a 0-5V DC signal?
An accelerometer has a seismic mass of 0.05kg and a spring constant of 3 x 10^3 N/m. Maximum mass displacement of 0.02m before the mass hits the stop. The maximum measurable acceleration will be
About power supply that cnanges AC to DC voltage and which a zener diode on it! jst need most the calculations of zener doide in this poer supply?
Water is sipped from an inverted conic-shaped-container whose altitude is 15 cm and radius 3 cm at the rate of 3 cubic cm per seconds. How fast is the depth of the water increasing when the wate
To sketch on common axis graphs to illustrate the response curve of secondary current against frequency when the coupling coefficient (Kc) is (i) equal to unity (ii) greater than unity(iii) less
Will a battery last longer if I charge it with a high current for a short time, or is it better to charge the battery with a low current for a long time to get the most energy? Our project will
What horsepower is added to water to pump it vertically through a 200-ft-long, 1.0-in.-diameter drawn tubing at a rate of 0.060 ft3 s if the pressures at the inlet and outlet are the same? 8.62
For the circuit of a full bridge single phase inverter, a. How many controlled pulses are needed over a half cycle of the output voltage to obtain 70% of Vac,max and, at the same time, eliminate
How can we write those operations just once, but allow them to be easily used whenever needed within a program or from many programs?
Sum up all the double words stored in memory area 60000h to 60100h. (Same problem as Program 5 on pg 166). Use good design and programming practices. Procedures: >> Why bother? What"s
Commercialization and Sales Potential (Do what you can in this section, more information here, may save time in evaluating your invention) a. List any past, present or contemplated public use or s
Register windows each have 6 input registers and 6 output registers. How many local registers are in each register window set? 7. A RISC processor has 186 total registers, with 18 globals. Dow
Why was the RISC architecture concept proposed? 2. Why is a RISC processor easier to pipeline than a CISC processor? 3. Describe how register windowing makes procedure calls more efficient. 4
With regard to printer output, how was the word spool derived? 4. Describe how multiprogramming systems differ from timesharing systems. 5. What is the most critical factor in the operation of
The conditional jumps can be predicted with 60% accuracy, and the loop jumps can be predicted with 90% accuracy. The penalty for guessing wrong is four cycles. There is no penalty for uncondit
Measure it and calculate the frequency to which the signal generator must be set. When using the Slotted Line connect a 3dB attenuator between the signal generator and the slotted transmission l
A circular coil of 150 turns is made of flexible wire. The cross-sectional area of the coil is 200cm^2. It is placed in a uniform B field of 0.600T (B field into page). The plane of the coil is
Question concerns low-pass filter. Given a RC low-pass filter and the values of the resistor, the capacitor and a frequency located within the band-pass, is it possible to determine the db loss
Given a low-pass RC filter, is it possible to determine "phase angle" and "db loss" given only a resistance, a capacitance and a frequency (not the cut-off frequency which obviously can be deter