Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
For each of the following systems with input x(t) and output y(t), state whether or not the system is (i) Linear and (ii) Time Invariant. Note that x(t) could be any complex valued signal. (a)
A 120/240V single phase transformer is connected as an autotransformer. Suppose that V1 is 120V at zero degrees and the transformer is ideal. Find V2, I1, and I2.
(1) If the frequency was changed, what would happen to the current in a circuit Explain increase or decrease. (2) If you have R = 2 K ohm, Xc = 3 K ohm, XI = 4 K ohm . Find the G, Bc, BI, Yt
if you use the sinusoidal waveform to drive the speaker: What change in the sound do you expect to hear when you increase the amplitude of the sinusoidal signal on the function generator
If there are 500 atoms in the sample and assuming that from any state all possible downward transitions are equally probably, what is the total number of photons that will be emitted when all atoms
Once the voltage across the load reaches 5V the load will no longer act as an open circuit and the capacitor will discharge. Once the load voltage has droped to 0.2 the load will act as an open cir
Suppose the one dimensional field A=Kx.ax exist in a region. Illustrate the validity of Gaussian theorem by evaluating its volume and surface integrals inside and the rectangular parallelepiped boun
Estimate the propagation delays of implementations (1), (2) and (3) using typical propagation delay data in the timing specifications of the logical gates of CD4000 family. Take the average propagat
A panasonic model Rx-ft560 stero uses a 12V_dc powwer supply. At full volume ( max triple min-bass) A max current of 1.4 amps is needed from the power supply. at min volume, this drops to 200mA. (hi
A tow truck applies forces F1 and F2 to the bumper of an automobile where F1 is horizontal. Determine the magnitude of F2 that will provide a vertical resultant force, and determine the magnitude of
Write a control algoirthm for a temperature control loop for a heat echanger (steam to hot water) employing a temperature control valve, controller, and thermostat. In your algorithm include a step
A long hallway has three doors, one at each end and one in the middle. A switch is located at each door to operate the incandescent lights along the hallway. Label the switches A, B, and C. Design a
A long hallway has three doors, one at each end and one in the middle. A switch is located at each door to operate the incandescent lights along the hallway. Label the switches A,B AND C. design a l
If a patient is on a drip with a drip rate of f(t) = 150e^0.0167t mL/hr, calculate the amount of substance transferred into the patient over a time period of 10 hours, use time intervals of 1 hour.
A window is etched through a 500 nm thick oxide on a [100] silicon wafer. The wafer is re-oxidized at 1100 °C using wet oxidation to grow a 750 nm thick film inside the window. Draw a cross-sect
If blood flows at a rate of 5 L/min for 3.5 minutes and then 4.5 L/min for 2 minutes, calculate the amount of blood that has moved through the body over the whole time period.
The EPROM should be mapped in a single block starting at address 0000 hex and the RAM should be mapped in a single block starting at address 8000 hex. 8051: Hardvard architecture with separate contr
Design an 8085 microprocessor system that has a total of 4Kx8 EPROM space using a single 4Kx8 chip and a total of 4Kx8 RAM using two 2Kx8 chips. The EPROM should be mapped starting at address 0000 h
the following binary numbers are all represented using 6 bit signed 2's complement. all addition should also be conducted in 2's complement form. A=111000; B=010110 (a) what is A's value in decimal
A 1 load draws 6 MW at 0.8 power factor lagging. Determine the reactive power required from a parallel capacitor to bring the power factor of the parallel combination up to 0.93
What would the effect of boundaries be on the diffusivity of a substance (e.g., if you have diffusion of a substance in a pipe, what would the effect of the pipe's walls be on the diffusivity
A 75 ohms lossless air transmission line at 3 GHz is terminated in a load of (300-j400) (a) What is the load reflection coecient (b) Determine the impedance at 2.5 cm, 5.0 cm, 7.5 cm and 10 cm from th
Given: The terminal pair of a hidden circuit has an open circuit voltage of 200 V. When a 50 k? resistor is placed across the terminal pair, a potential of 80 volts is observed. Required: Determine
Write a loop to count the number of 1's in the array. If there is an even number of 1's in the array then the OddParity variable will be set. Create a bit-array of 10 elements with appropriate valu
find a minimal two-level NAND realization for each of the following switching functions. a) f(A,B,C) = sum m(0,2,3,7) b) f(A,B,C,D) = sum m(0,2,8,10,14,15) c) f(A,B,C,D,E) = sum m(4,5,6,7,25,27,29,31)