Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
Use Smith Chart: A 100 Ohm air-coaxial transmission line is measured to have an input impedance of 100 + j100 Ohms. If the system is operated at 100 MHz and is one meter long, what is the terminatin
Shuffle a deck of cards and pick two cards at random. Observe the sequence of the two cards in the order in which they were chosen. (a) How many outcomes are in the sample space
A standard 12-V car battery has an ampere-hour rating of 30 Ah, whereas a heavy-duty battery has rating of 51 Ah. Calculate the ratio of available energy and the percentage increase in available cur
A rod on the surface of Jupiter's moon Callisto has a volume of 0.3 cubic meters. Determine the weigh of the rod in units of pounds-force. The specific gravity is 4.7 gravitational acceleration on C
What is the perceived colour if the energy of light is same corresponding to red green and blue,and zero at other frequencies what about red and green frequencies only
A four-bit binary number is represented as A3A2A1A0, where A3, A2, A1, and A0 represent the individual bits and A0 is equal to the LSB. Design a logic circuit that will produce HIGH output whenever
The heavy-duty rechargeable battery you selected can provide a continuous 9A of current at 12 V for a 4-hour period of operation each night before being completely drained.
Let x and y be Bernoulli randon variables that take on values 1 and 0. X is distrubuted with p = 0.5. What distribution on y will maximize the Kullback-Leibler divergence (D(x||y)
Design a circuit with output f and inputs x1, x0, y1, and y0. Let X=x1x0 and Y=y1y0 represent two 2-digit binary numbers. The output f should be 1 if the numbers represented by X and Y satisfies X&g
A photoresistor is connected series to a battery of 10 V with internal resistance of 5 Ohms. The ohmic resistance of the photoresistor changes by time through the day and expressed as: RLDR=20-(10/t
An instructor in Engineering Department has the following grading policy: "Curving of grades is achieved by adding to every grade the difference between 99 and the highest grade in the class"
Build a series circuit consisting of a 130 V 60 Hz ac source, a 5 ohm resistor, a 53.05 mH inductor, and a 0.33156 mF capacitor. a) Draw the ac circuit diagram b) Sove for the phasor c
An Ideal Low Pass Filter: The impulse response of an ideal low-pass filter is h(t) = sin(t)/t (or the sinc signal). (a) Given that the impulse response is the response of the system to an input x(t)
Let x(t) = u(t) u(t 1).Find the average signal y(t) using the above integral. Let T = 1. Carefully plot y(t).Verify your result by graphically computing the convolution of x(t) and the i
If a silicon diffusion is doped with phosphorus (donors) at a concentration of 0.6 x 10^17/cm^3, what is the concentration of holes in this piece of silicon per cm^3 Assume ni = 1.45 x 10^10/cm^3, n
Shuffle a deck of cards and pick two cards at random. Observe the sequence of the two cards in the order in which they were chosen. (a) How many outcomes are in the sample space (b) How many outcomes
A vibration trandsucer measures a sinusoidal signal with up to a 100-hz frequency and an amplitude of + and - 5 v. Superimposed on this signal is an additional signal with a freq of 1000 hz. an
A binary channel with capacity 36 k bits/sec is available for PCM voic transmission. If signal is band limited to 3.2 kHz, then what will be the appropriate values of quantizing level L and the samp
What is the propagation constant at 500 MHz. Use the fact that the velocity of an EM wave in a lossless air-filled line is the same as that of free-space propagation in air. That is, the propagation
1. Use the Quine-McCluskey minimization method to find a minimum cost SOP realization of the following functions (a) f(x1,x2,x3,x4)= fm(0,2,4,5,7,8,9,15) (b)
A Vs equals 1V source impedance 25ohms is connected by a switch to a 50-ohms lossless air transmission line 1 m long, terminated in a load of 30-ohms. At time t=0s, the switch is closed instantaneou
A 75-ohms lossless transmission line is terminated in a load ZL = 80+j60. The line is length lamda/8 long and connected to a line Z0= 50-ohms. What is the input impedance on the 50-ohms line, lamda/
(a) ZL = 80+j60 , what is the load reflection coecient. (b) Design a short circuit stub matching circuit to match the load to Z0 of 50-ohms. State the distances in wavelengths and in centimeters.
Nanowire with square cross-section: Starting with the time-independent Schrodinger equation: (a) use separation of variables to obtain three ordinary differential equations (ODEs) (b) solve the ODEs a
A coaxial line is filled with a very slightly lossy material with a relative dielectric constant of 5 The line would have a characteristic impedance of 100 ohm if it was air-filled. (a) What is the ch