Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
use series to approximate values of functions. Therefore it is important that we know for which values of x the series will provide good approximations of the given function. Based on the graph can
A ball is dropped from a height of 10 feet. Each time it strikes the ground, it bounces up to 80% of the previous height a.What height will the ball bounce to after it strikes the ground for the third
Design a UV flip-flop using a JK flip-flop and two logic gates. where the characteristic table for the UV flip flop is U V Q(t+1) 0 0 1 0 1 !Q(t) 1 0 Q(t) 1 1 Q(t)
Find the range of values of "k" for which the system has two real, distinct, and stable poles. c) Find the value of k such that the system has a percent overshoot between 5% and 10%. d) Find the sys
A) How far is the spring stretched at the equilibrium postion B) How much potential energy is stored in the spring C) the mass is pulled down a distance of 4.50 cm and released. How fast is the mass
Steam at 10 MPA, 600 C, enters a well insulated turbine operating at steady state and exits at 0.1 bar and a quality of 92%. The volumetric flow rate at the inlet is 0.36 m^3/s. Assuming the kinetic
1. Find the system transfer function H(z). 2. Find the impulse response h(n) for the system. 3. Find the inverse transfer function H-1(z). 4. Find the impulse response h(n) for the inverse transfer
(a) Calculate the length of the blades of a 1 MW wind turbine. Assume the air density is 1.0 kg/m^3, average wind speed is 15 m/sec, and overall efficiency is 25%. (b) An ideal solar cell is operati
Consider a BPSK signal where each bit is represented by a triangular pulse with width T and height A. What is the "energy per bit" for this BPSK pulse with A=1V and T=0.002s
A 1.4 mF capacitor has initial voltage of 19 V.The energy stored in the capacitor is used to light up a 0.5 KOhm lamp.Assuming that the lamp is completely dimmed when the current through it is less
A three resistors connected in series with a DC power supply of 12 volts with a return path to the negative terminal of the power supply also connected to ground. The first resistor is labeled "R1",
The voltage drops across three resistors in series are measured to be 10.0V, 15.0V, and 25.0V. If the largest resistor is 47.0 ohms, what is the value of the smallest resistor
Design a timer system that has a push button, LCD and RTI. When you press the push button, the timer starts counting each second and displays the seconds' value on the LCD. When you press the timer,
Create a sequence detector that recognizes the following sequence on input X with overlap: "1011101", and sets the output Y to 1 when the sequence has been detected. a) Provide the state diagram and
Write the theoretical Power Spectral Density for a BPSK signal with shift angle of 180 degrees, carrier of 25 kHz and bit rate of about 1 kHz that has been spread by a PN sequence with a bit rate of
1. Find cross-correlation sequence for x and y. 2. Find autocorrelation sequence for x and y. 3. Find the convolution sequence z(n) for x and y. 4. Plot above three sequences using MATLAB and verify
1. Calculate the sample values for one period. 2. What is the Nyquist sampling rate for this waveform 3. If the samples are converted to 8 bits, find bits for each sample values. 4. What is the quan
Design an FSM that realizes a three-bit Gray-code counter, which counts in the sequence 000, 001, 011, 010, 110, 111, 101, 100, 000
(a) At t = 0, the current flowing in a 0.5-H inductance is 4 A. What constant voltage must be applied to reduce the current to 0 at t = 0.2 s (b) Starting at t = 0, a constant 12-V voltage source is
Two one phase loads, a 5kW resistor, and a 10kVA load with a 0.707 lagging power factor are connected in parallel to a 120 V source. What is The power factor of the current supplied to the two loads
The user of your program will know the employee's name and the gross pay for the employee. Each employee has the following deductions taken from his gross pay: Federal Income Tax: 15% State Tax: 3.5
A "shift and add" multiplier works as follows: given two n bit numbers X and Y , look at the LSB of X: if it is one, then add Y to the running sum. If it is zero, then don't do anything (since multi
A unity-feedback control system has plant transfer function g(s)=(k(s+2))/(s(s^2+4s+16)) Construct the root locus including asymptote angles, cg, break-in points and departure angles as needed for
The triggering device for an automobile airbag restraint is required to have a reliabil-ity of 95 per cent when tested on an impact test rig. This reliability is to be established at 90 per cent con