Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
what is the frame relay in which layer it comesans frame relay is an industry standard shared access switched data link layer encapsulation that
gateway a device linked to multiple physical tcpip networks capable of routing or delivering ip packets among themrouter its a layer 3 device that
a network in which there is multiple network links among computers to provide multiple paths for data to
when the computers on the network basically listen and receive the signal they are referred to as passive due to they dont amplify the signal in any
a peer-to-peer networkcomputers can act as both servers sharing resources and as clients using the resourcesb server-based networkgive
what is difference between baseband and broadband transmission in ccnaans in a baseband transmission the entire bandwidth of the cable is consumed by
a method used to standardize and categorize fault-tolerant disk systems raid levels give lot of mixes of performance reliability and cost some
normal 0 false false false en-in x-none x-none microsoftinternetexplorer4
an industry standard suite of protocols for the use of point-to-point links to transport multiprotocol
10base2 an ethernet term meaning a maximum transmitting rate of 10 megabits per second that uses baseband signaling with a contiguous cable segment
what are the two types of transmission technology available in ccnaans point - to - point and broadcast are the two types of transmission technology
communication is the process of sending and receiving data by means of a data cable that is associated externallytransmission means the transmitting
used in ip networks to break up larger networks into slighter subnetworks it is used to decrease network traffic optimized network performance and
vlan - virtual local area networkvlan is a logical grouping or segmenting a network linked to administratively described ports on a switch they give
ping - packet internet gophera utility that shows connections to one or more remote hosts the ping command uses the icmp echo request and echo reply
what must be true for two routers running igrp to communicate their routesans similar autonomous system number
the three phase of ppp session establishment are- a link establishment phase b authentication phase c network layer protocol phase
what is the difference among url instance and url connection instanceans a url instance represents the location of a resource and a url connection
the compression protocols for ppp are-a stac b predictor
as the system administrator you type ppp authentication chap pap secret name the authentication method is used first in setting up a sessionans
which form of ppp error detection on cisco routers monitors data dropped on a link ans the quality protocol monitors data dropped on a link magic
state the statements about ppp and slip for wan communications ans a ppp uses its network control programs ncps component to encapsulate
name the physical interfaces that ppp can be configured on a cisco router ansa asynchronous serial b hssi c isdn d synchronous
what is the juncture at which the cpe ends and the local loop portion of the service starts ans the demarcation or demarc is the juncture at which
when using access lists it is important where those access lists are placed which statement best defines access list placementans put standard access