Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
consider a spring-mass sliding along a surface providing coulomb friction with stiffness 12 x 104nbspnm and mass 10 kg
a spring-mass system with coulomb damping of 10 kg stiffness of 2000 nm and coefficient of friction of 01 is driven
a system of mass 10 kg and stiffness 15 x 104nbspnm is subject to coulomb damping if the mass is driven harmonically by
a spring-mass system m 10 kg k 4 x 103nbspnm vibrates horizontally on a surface with coefficient of friction mu 015
numerically integrate and plot the response of an underdamped system determined by m 150 kg and k 4000 nm subject to
a dvd drive is mounted on a chassis and is modeled as a single-degree-of-freedom spring mass and damper during normal
a cam in a large machine can be modeled as applying a 10000 n-force over an interval of 0005 s this can strike a valve
determine the response of an undamped system to a ramp input of the form ft f0nbspt where f0nbspis a constant plot the
from a compliance transfer function of a spring-mass-damper system the stiffness is determined to have a value of 05 nm
numerically simulate the response of an undamped system to a ramp input of the form ft f0nbspt where f0nbspis a
what natural frequency must a hand drill have if its vibration must be limited to a minimum rms displacement of 10 mum
a 100-kg machine is supported on an isolator of stiffness 700 x 103nbspnm the machine causes a vertical disturbance
a harmonic force of maximum value 25 n and frequency of 180 cyclesgtmin acts on a machine of 25 kg massdesign a support
consider a machine of mass 70 kg mounted to ground through an isolation system of total stiffness 30000 nm with a
a 350-kg rotating machine operates at 800 cyclesgtmin it is desired to reduce the transmissibility ratio by one-fourth
a 68-kg electric motor is mounted on an isolator of mass 1200 kg the natural frequency of the entire system is 160
a rotating machine weighing 4000 lb has an operating speed of 2000 rpmit is desired to reduce the amplitude of the
the instrument board of an aircraft is mounted on an isolation pad to protect the panel from vibration of the aircraft
design a base isolation system for an electronic module of mass 5 kg so that only 10 of the displacement of the base is
calculate the damping ratio required to limit the displacement transmissibility to 4 at resonance for any damped
a small rotating machine weighing 50 lb runs at a constant speed of 6000 rpm the machine was installed in a building
a 3000-kg machine tool exhibits a large resonance at 120 hz the plant manager attaches an absorber to the machine of
a motor-generator set is designed with steady-state operating speed between 2000 and 4000 rpm unfortunately due to an