Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
application radar cross-section a small radar is used to measure the radar cross-section of a small airplane as part of
questiongiven z13j4 z25-j5compute the following quantities result should be expressed in rectangular forma z1z2b z1-z2c
develop a test procedure to check the circuit board in figure 82 to make sure that there are no open components you
application single stub matching a 75 omega tv cable is used to connect to a tv the load is matched to the line figure
application double stub matching an antenna has an impedance of 68j10omega the antenna needs to be connected to a 75 n
application lambda4 transformer show that two lines with any characteristic real impedances z1 and z2 may be matched
in example 163 suppose that the amplitude of the reflected wave equals 99 of the amplitude of the forward-propagating
application lambda4 transformer a two-wire transmission line has characteristic impedance of 300 omega and connects to
application single stub matching a transmission line is loaded as in figure 1534 if the wavelength on the line equals 5
matching with shortedopen loads the transmission line network in figure 1532 is given the shorted transmission line and
the steady state solution for a dc source on a loaded line does not require the use of the multiple reflections method
application inductively loaded transmission line a long lossless transmission line with characteristic impedance of 500
fields in shorted waveguide a parallel plate waveguide operates in a tm mode and has the following electric and
tm fields in parallel plate waveguide a parallel plate waveguide is made with very large infinite planar conductors as
propagation in discontinuous waveguides two parallel plate waveguides are connected as shown in figure 1724 the
application tetm waves in strip lines a parallel plate waveguide is made of two wide strips separated by a fiberglass
application modes in rectangular waveguide a wr 112 standard rectangular waveguide with dimensions a 2850 mm and b
application fields and power in rectangular waveguide a rectangular waveguide is used to transmit power from a
application tunnels as waveguides the following communication system is proposed for communication in mine tunnels to
dielectric losses in waveguides a rectangular waveguide is filled with a lossy dielectric with relative permittivity
resonant frequencies in rectangular cavity a rectangular cavity resonator is 60 mm long 30 mm high and 40 mm wide and
resonant frequencies in shorted waveguide the wr 284 waveguide is made into a cavity 05 m long by shorting the
application design of a cavity for given resonant frequencies a cavity resonator is built from a section of a waveguide
application parallel plate resonator a parallel plate waveguide is shorted at two locations as shown in figure 1732 the