Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
An FM signal has a carrier frequency of 200 kHz, a modulating frequency of 500 Hz, and a frequency deviation of ± 40 kHz. Determine the approximate transmission bandwidth (in kHz).
Referring to the information above, if one were to sum all of the different average power values associated with the carrier and all sidebands, determine the total value of average power (in watts).
a total charge Q is uniformly distributed around a ring shape conductorwith radius a.a charge q is located at a distance x from the center of the ring ....the force exerted on a charge is given by F
a) Construct a state table and the state graph for the given network. b) What is the the output for the following input secuence X=01011. note: Di and Qi are the input and the output respectively of e
Desing a logic Circuit that receives an array X(4 bits:X1,X2,X3, and X4) and makes it available as an output O(4 bits: O1,O2,O3, and O4) after one clock delay, subject to the control of input signal
Desing a logic circuit that implements a serial adder/subtracter with accumulator for a 6-bit binary number. you should use one of the imputs to select between the adder and the subtracter. Asumme t
When placed in series a coil and capacitor resonate at a fequency of 2251Hz and when placed in parallel they resonate at a frequency of 2228Hz. At parallel resonance it is also found that a current
Find the charge on the capacitor in an LRC series circuit at t = 0.01 s when L = 0.05 h, R = 2 O, C = 0.01 f, E(t) = 0 V, q(0) = 5 C, and i(0) = 0 A. Determine the first time at which the charge on
Design a Mealy sequential machine with two inputs A and B, and one output Z. Output Z generates 1 if: (a) A had the same value at each of the two previous clock ticks, or (b) B has been 1 since the
A long solenoid with 11.9 turns/cm and a radius of 5.76 cm carries a current of 18.2 mA. A current of 4.77 A exists in a straight conductor located along the central axis of the solenoid.
If we want to receive an FM station that broadcast on frequency = 100 MHz and we have to build a tunning circuit of LC utilizing a capacitor of 10pF. Design an inductor L to make tune by using your
A parallel-plate transmission line is comprised of two perfect conductors of width w lying in the planes x = 0 and x = d. At z =z1 and the time t, the power flow is 8 kw and the electric and magneti
If you have a purely inductive load with a reactance of 2/377 O connected to the 120Vrms 60 Hz (i.e., f = 377 rad/sec) AC line, what value of capacitor (in Farads) must be put in parallel with it to
design an alarm clock using VHDL and implement in FPGA (Basys2 Board). the scope is that, when the time and alarm time are equal, then alarm rings. A sign or some kind of indication will be shown on
Determine whether the following discrete-time systems are causal or noncausal, have memory or are memoryless, are linear or nonlinear, are time invariant or time varying. In the following parts, x[n
A linear time-invariant continuous-time system responds to the following inputs with the corresponding outputs:Ifx(t) = u(t), then y(t) = 2(1- e^-t)u(t) and if x(t) = cost,then y(t) = 1.414 cos(t -
A modulating signal consists of two sinusoidal components: 1 kHz and 3 kHz. The transmitter carrier frequency is 80 kHz. Assume in a SSB-USB modulated signal that the inserted carrier at the receive
A modulating signal consists of two sinusoidal components: 1 kHz and 3 kHz. The transmitter carrier frequency is 80 kHz. If the signal is applied to a SSB-LSB transmitter, indicate the output freque
write a program to compute the power loss in a transmission line with a resistance of .05ohms/mile. compute the power loss if 500kw of power is transmitted from a power generating station to cities
where H is an A/M and B is in T. If a magnetic circuit contains a 12 cm length of material X, as well asa 0.25 mm air gap, assume a uniform cross section of 2.5 cm2 and find the total mmf (Vm) to pr
A modulating signal consists of two sinusoidal components: 1 kHz and 3 kHz. The transmitter carrier frequency is 80 kHz. If the signal is applied to an ideal DSB transmitter, indicate the output fre
Determine the Thevenin equivalent of the network shown on the left and determine the current - determine the complex power generated by the (ideal) 400V source.
The total bandwidth allocated is 200MHz . The signal-to-interference-ration required is 18 dB. Propagation path loss exponent n = 3 and omnidirectional antennas for the base stations are used. ?1)
The dielectric constant of a solid is 5. It is placed between the plates of a capacitor which are 1mm apart and which are charged to 100 V. Calculate the capacitance per square metre of this device