Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
If each packet carries 1000 bitsof data, the distance between the sender and receiver is 5000km,link speed is 1Mbps, and the propagation speed is2x108 m/s. Assume no data or control frame is lostor
Given coaxial cable with an inner conductor with radius a and anouter conducrot with radius b, find B forρ>b when the inner and outer currents are +100[mA] and-90[mA], respectively, and both
A series RC circuit is powered by a voltage supply of 120Vac and60Hz. The resistor has a resistance of 80W and capacitive reactanceis 60W. (1) Sketch a schematic for this circuit (2) Determine th
Assume that γ and Z0 are given 2- A dc generator of voltage Vg and internal resistance Rg is connected to a lossy transmission line characterized by a resistance per unit length R and conducta
Design the 4-bit adder/subtractor circuit with look ahead carry circuit. Draw a logic circuit diagram of your circuit with pin numbers on all logic gates.
Phase 'A' of a three-phasee 4.16 kV ungrounded system is solidly grounded. For this fault, calculate the magnitude of the positive, negative, and zero sequence voltages at the fault.
Write the magnitude function for a third order Chebyshev filter having a ripple coefficient of 0.4. Do not expand. Also find the cutoff frequency.
Design a one-op-ampactive band pass filter that has a midband (at 5 KHz) inputimpedance of approximately 10K, a midband gain of approximately 1and a frequency response from 1 to 10KHz(corner frequen
Instead the circuit designerdecides to use a short circuited transmission line to create the same reactance as the capacitor at1.6 GHz. Lossless 75 Ohm microstrip lines are used on the 3 mmthick cir
Design first order and high-pass filter that has a gain of 10 and corner frequency of 0.05Hz. Verify your design using transfer function and frequency response.
The axon action potential voltage ranges between -100mV to 50mV. Design a basic circuit that will amplify the AAP so the output is in the range 0V-5V.
Design a circuit that sounds an alarm if motion is detected in more than one room at a time. Show all design steps (truth table or equation(s),minimization using K-map(s), and logic diagram(s).
A friend of yours claims that the output of any LTI system corresponding to the input x(-t) is y(-t), i.e., time-reversal of input results in time-reversal at the output. Verify this claim,i.e., pro
a) Consider an n-p-n transistor whose base emitted drop is0.76 at a collector current of 10mA, What current will it conductat Vbe=0.70V. What is the base emitted voltage for ic=10microampere. b)A CE
find the current that flows in a silicon bar of 10 micrometerlength having a 5 X4 micrometer cross section and having freeelectron & hole densities of 10^5/cm^3 & 10^15/cm^3 ,respectively, w
A star network with a hub, and 3 nodes: Transmission rate R=10Mbps, Frame length L=1000 bits, Cabledistances from the hub to the nodes are d1=d2=100 meters,d3=200meters. Propagation speed is the spe
NA (x) = 10^14 + 10^18exp(-10^4x), where x is measuredin cm. Use Eq. to demonstrate that the material must have a nonzero internal electric field E. What is the value of E at x=0 and x =5μm
In the pure resistive circuit the current is not not legging, while the resistor provides opposition to the flow of current. Does Current leggs behind the voltage in pure resistive circuit or not.
Write a software that programs counter 2 to generate an 80 KHz square wave if the CLK input to counter 2 is 8MHZ.
Consider an ideal 12-bit ADC with Vref=5V is used to sample a1v p-p sinusoidal signal that has a 2.5v offset. What is the boolean output if the input voltage is 3.333v
Sketch the magnitude characteristic of the transfer function H(jw)using a Bode Plot. Label all critical values and identify the typeof filter the circuit represents. use C= 1000u F, L = 10H, AND R
Every 64 cycles, the circuit outputs the average ofthe past 64 input V values, then in the next cycle begins a new calculation (in other words, its behavior repeats). During the cycles when the circ
Design an inverting op-amp circuit for which the gain is -5V/V and the total resistance used is 120kΩ
A 5.6 mF capacitor has initial voltage of 18 V.The energy stored in the capacitor is used to light up a 0.1 kOhm lamp. How much will be the lamp's power 6.7 sec after the switch has been turned on
Consider a power-output stage with voltage gain A1=1, an input signal Vs=1V, and a hum Vn of 1V. Assume that this power stage is preceded by a small-signal stage with gain A2 =100V/V and that overal