Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
an iron-constantan thermocouple is referenced at 32degf and has an output voltage of 45 mv what is the temperature at
an iron-constantan thermocouple is used to measure the temperature in an oven the cold junction is at ambient
a potentiometer with a total range of 350deg has a linearity of 025 and is connected to a 10-v source if the pot is
a 350deg wire-wound potentiometer has 300 turns and a total resistance of 1 k what is the resolution in ohms in
a 350deg pot is connected to a shaft through a 31 gear ratio the pot rotates three times further than the shaft the pot
a pot with a total range of 350deg is supplied with 5 vdc the output of the pot is converted to binary with an 8-bit
a 350deg pot is connected through a 4 1 gear ratio to a shaft that rotates 80deg the pot rotates four times further
an absolute optical rotary encoder has five tracks how many bits is the output and what is the resolution in degrees
an incremental optical rotary encoder has 720 slots starting from the reference point the disk turns 200 slots cw then
the counter for a 500-slot incremental optical rotary encoder has a value of 101100011a what is the resolution in
position data from a pot is being processed to yield velocity data the sample period is 05 s the position is 68deg at
data from an optical shaft encoder are providing velocity information the sample period is 025 s the present data are
a 18deg stepper motor turns a lead screw that has 24 threads per incha how many steps will it take to advance the lead
a 75deg stepper motor four phase controlled by a computer is used to position a telescope through a gear train the
a dc motor is running with a line voltage of 90 v a cemf of 80 v and an armature resistance of 3 find the armature
a motor generates a cemf at a rate of 05 v100 rpm and has an armature resistance of 15 twelve volts are applied to the
a pm motor supplied with 10 v has the torque-speed curves of figure 710a find the stall torqueb find the no-load speedc
in the reduced-voltage-starting circuit of figure 934a what is the purpose of relay mrb what is the purpose of relay
a stepper motor is being used as a crane motor in an expensive toy the motor has the following properties holding
a 75deg stepper motor is commanded to go 50 steps ccw 27 steps cw and 35 steps ccw again what is its final angle
a single-phase voltage waveform is shown in figure 92a what is the voltage between prong a and ground at 270degb what
an induction motor is powered by 120 vac at 60 hz and runs at approximately 1200 rpm what pole motor must this
what is the synchronous speed of a 400-hz eight-pole single-phase motor how many individual poles does it
draw a diagram of a capacitor start motor which incorporates a centrifugal switch explain what happens during the
draw a diagram of a complete hydraulic system from tank to actuator and identify each system