Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
a 10-hp 230-volt shunt-wound motor has rated speed of 1000 revmin and full-load efficiency of 86 percent armature
a self-excited dc shunt generator is delivering 20 a to a 100-v line when it is driven at 200 rads the magnetization
a 50-hp 230-volt shunt motor has a field resistance of 177 omega and operates at full load when the line current is 181
the per-phase impedance of a 600-v three-phase y-connected synchronous motor is 5 j50 omega the motor takes 24 kw at a
a 10-hp 230-v 60 hz three-phase wye-connected synchronous motor delivers full load at a power factor of 08 leading the
a single phase transformer rated 150kva vp72kv vs240vbulltransformer secondary winding leakage reactance xs 007
a balanced 3-phase circuit with wye connected source supplies a delta connected load trough a short transmission line
three similar primary cells are connected in series to form a closed circuit as shown in given figure each cell has an
the no-load test of a single-phase induction motor is made by running the motor without load at rated voltage and rated
a 200-v 60-hz 10-hp single-phase induction motor operates at an efficiency of 086 and a power factor of 09 what
a 230-v 50-hz two-pole single-phase induction motor is designed to run at 3 percent slip find the slip in the opposite
a permanent-magnet stepper motor with a 15 step angle is used to directly drive a 0100 in lead screw determinea the
a pm stepper motor has six poles and a bipolar supply ie the current into each coil pair can be either positive or
with reference to the triangular speed profile of figure p184 determine the trapezoidal speed profile required to move
for the network shown in given figure calculate the currents in each of the
an industrial plant has a load of 800 kw at a power factor of 08 lagging it is desired to purchase a synchronous motor
the power required to drive a fan varies as the cube of the speed if a motor driving a shaft-mounted fan is loaded to
a 5-hp 1150-revmin shunt motor has its speed controlled by means of a tapped field resistor as shown in figure p1831
determine vab in the network shown in the attached
a three-phase induction motor is required to operate from a single-phase source one possible connection is shown in
a 240-v 60-hz two-pole universal motor operates at a speed of 12000 revmin on full load and draws a current of 65 a at
the periodic current waveform of given figure is composed of segments of a sinusoid finda the average value of the
the design for a 18 -hp two-pole 115-v universal motor gives the effective resistances of the armature and series field
if v1 10 v v2 15 v r1 4 ohm and r2 6 ohm in the circuit of given figure find the thevenin equivalent for the
the physical head of an impoundment power plant is 100 m when the penstock is fully closed the pressure at the outtake