Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
A concentric tube heat exchanger is comprised of a thin wall inner tube of 25.4 mm diameter and an outer tube of 47 mm diameter.
Solve the questions of the beam ABCD. Note that A is a fixed end; B is a pin connection; C is a roller support; and D is a free end. Draw the quantitative influence line for the bending moment at poin
You are required to select a real non-domestic building with which you are familiar and carry out an analysis of its energy performance. Explain the general importance of energy performance in indus
What are the primary benefits of using computerized layout procedures versus Systematic Layout Planning (SLP) procedures done by hand?
There are two benchmark problems which AISC has adopted to find whether an analysis method meets the needs of a rigorous second-order analysis adequate for use in the Direct Analysis Method (DAM)App
To provide knowledge and practice AutoCAD software package for engineering activities.As a professional Engineer, you have been assigned by your company to prepare an engineering drawing for a bunga
Write a well-documented MATLAB program to simulate the groundwater aquifer at this site by computing the groundwater head with a spatial resolution of 1 meter in the x-direction and 1 meter in the
Your brief is to imagine that, as the engineering designer for this project, you have been asked by the clients (i.e. the owners of the project) to provide them with a report on issues of sustainabi
Develop a simple urban constructed wetland design guidelines and drawings. Your report should include the following: Data required for the design, Types of constructed wetland.
Explain wave set-up and set-down in the nearshore in terms of wave transformation processes and the resultant spatial gradients in the radiation stress.
Using force method, determine the reactions at supports A and C in the shown beam and draw the bending moment diagram. Point B is an intermediate hinge. EI is constant.
The cantilever beam-like structure shown in figure below is modelled using a 2 x 10 mesh of rectangular four-node plane stress elements of equal size. Construct the element load vectors and global l
Working from the attached floor plan and the photo given below, you are needed to reproduce in 2D and 3D a bungalow similar to picture given below fully utilising where proper various styles and lay
Calculate the factor of safety (Fb) against basal heave failure using Bjerrum and Eid’s method.
Out of a long-term record of precipitation for four adjacent stations you find that records of one station (station D) are missing for the spring months, September, October, and November for the yea
Lake Kickapoo, TX, is approximately 12 km in length by the 2.5 km in width. The inflow for month of April is 3.26 m3/s and outflow is 2.93 m3/s. The total monthly precipitation is 15.2 c
Describe the purposes of equalization basins, grit chambers, primary sedimentation tanks, and waste stabilization ponds in wastewater treatment.
Calculate the horizontal deflection of joint D produced by both the load and fabrication error (bar AE is 30mm too long).
It is proposed to construct a 3m diameter, 50m long tunnel, heading 0950, through the andesite lava flow at Maori Bay (Muriwai).
Determine the natural circular frequencies and natural modes of vibrations of the frame and provide sketches of these.
Client is considering building a four story dual usage flats suitable for both residential and office usage to replace an existing two story building.
Your School must show evidence of sustainability, in terms of both construction and operation.
Develop a table for the water quality parameters of surface water (rivers and lakes), and groundwater.
Sketch the water surface profiles for the cases below. Label the normal and critical depth lines as well as all of the water surface profiles.
The V-block clamp comprises of 3 components, a V-block, yoke and clamping screw. By using a rule, measure the sketches below and produce a third angle projection drawing for each component.