Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
The ionization constant Ka of the indicator chlorophenol redis 1.0x10^-6. The color of the nonionized form of the indicator(HIn) is yellow and that pf the ionized form (In-) is red. What is the colo
A certain element has two isotopes with Abundance and Mass as 73%, 99 amu, and 27%, 118 amu. How do you find the atomic weight of the element in amu?
Vanillin, C8H8O3, occurs naturallyin vanilla extract and is used as a flavoring agent. A 42.5-mg sample of vanillin was dissolved in181.5 mg of diphenyl ether,(C6H5)2O. What is the molality of vanil
A 48-g sample of a gaseous fuel mixture contains 0.57 mole fraction propane,C3H8; the remainder of the mixture is butane,C4H10. What are the masses of propane and butane in the sample?
A generic vinegar, 4.5 % acetic acid, costs 95 cents for an 8 oz bottle and $ 2.79 for a quart bottle. which is cheaper? Calculate the cost of each bottle in $/g acetic acid.
Dilute Hydrochloric acid is added to a 0.500 g sample of alloy containing zinc and copper. The gas evolved (79.7 mL) is collected over water at 23 C and the barometric pressure of 737 mmHg.
How many stereoisomers can be obtained from the monobromination of butane? How many stereoisomers with the formula CH3CHICHICH3 arepossible?
Photosynthesis is aprimary source of food and energy for almost all living organisms. Recently, scientists have found living organisms in deephydrothermal vents in oceans. These organisms produce fo
A student tried to prepare 1-phenylpentane-1,5-diol bya Grignard synthesis using 4-bromo-1-butanol and benzaldehyde. None of the desired products was obtained, but the student did isolate a small am
The molar heats of sublimation and fusion of iodine are 62.3 KJ/mol and 15.3 Ky/mol respectively. Calculate the molar heat of vaporization of liquid iodine.
The solubility of compound A in ethanol is 0.4 g per 100 ml at 0degrees celsius at and 5.0g per 100 ml at 75 degrees. What is the minimum amount of solvent needed to recrystallize an 8.0 g sample of
What would be the maximum theoretical percent recovery from the crystallization of 5.0 g of acetanilide from 100 ml water. (assuming the solution is chilled at 0 degrees celsius)
During recrystallization , an orange solution of a compound in hot alcohol was treated with activated carbon and then filtered through fluted paper.
You set up a bomb calorimetry experiment using 1 liter of water as your heat sink and combusting a 4.409 g sample of propane(C3H8). If the initial and final temperature are 24.90 degree Celcius and 77
Imagine that this reaction occurs in a container that has a piston that moves to allow a constant pressure to be maintained when the reaction occurs at constant temperature.
Impure acetanilide was dissolved in hot water . the solution was filtered hot and the beaker of solution was immediately placed inan ice- water bath instead being allowed to cool slowly.
The solubility of compound A in ethanol is 0.4g per 100ml at 0degrees celsius and 5.0g per 100 ml at 75 degreescelsius. What is the minimum amount of solvent needed torecrystallize an 8.0g sample of
Assume that 3.0g of aniline and 4.5ml of acetic anhydride areused in the preparation of acetanilide. What is the limiting reagent? What is the theoretical yield of the acetanilide?
What properties are necessary and desirable for a solvent inorder that it is well suited for recrystallizing a particular organic compound?
A hot solution of a particular compound was allowed tocool to room temperature. After waiting a few minutes, it was noticed that the crystallization had not taken place.
You must set up a bomb calorimetry experiment using 1 Liter ofwater as your heat sink and combusting a 4.409g sample of propane(C3H8). If the initial and final temperature are 24.9 deg C, and77.96
Calculate the amount of calcium hydroxidein grams that is required to neutralize 1.00L of 0.850M phosphoricacid. Support your answer by providing the corresponding chemical equation.
In what form is the product (the chlorobenzoic acid) in the clearfiltrate after the brown precipitate has been removed? After the addition of the hydrochloric acid?
Assume that your product has a mp of 187-190 C. Even though this value does not match any of the isomers, you could still reasonably state which chlorotoluene you started with. Explain.
A gas phase reaction involves N2O5 decomposition to NO2 and O2 in aclosed flask with a total volume of 3.71 L. If the reaction isfirst order with respect ito N2O5 and initially the flask contains553