How much work do we gain or perform, Physics

+44 141 628 6080
[email protected]

How much work do we gain or perform

(a) To a closed system we add 28 kJ of heat while its internal energy decreases by 24 kJ. How much work do we gain or perform? (Everything reversible)

(b) If we do not gain/perform work, how much heat is exchanged (internal energy change same as in part (a))?

Request for Solution File

Ask an Expert for Answer!!

Physics: How much work do we gain or perform

Reference No:- TGS0738151

Expected delivery within 24 Hours

Have a Question? (oR Write a Review)

Write atleast 100 words!!

Recent Questions Asked Physics

Q : How much is the mass rate for the outlet gases

How much is the mass rate for the outlet gases that is needed to get an initial acceleration of one standard gravity, i.e., 9.8 m/s2?

Q : What is the power output of the turbine for a mass flow rate

Steam enters an adiabatic turbine at 3 MPa and 350 celsius and leaves the turbine at 75 kPa with a quality of 89%. IF you can neglect the potential energy effects, the inlet velocity is 100 m/sec and the ratio of the outlet area to the inlet area

Q : Determine a strain in the transverse direction

A bar of high strength aluminum alloy is 150 mm long and has a circular cross section of diameter 40mm. It is subjected to a tensile load of 250kN, which gives a stress well below the material's yield strength.

Q : What is the overall efficiency of the plant

If the plant uses 28.7 kg/s of coal as its fuel and coal has a nominal heating value of 32,000 kJ/kg, what is the overall efficiency of the plant (in percent)?

Q : How much work do we gain or perform

To a closed system we add 28 kJ of heat while its internal energy decreases by 24 kJ. How much work do we gain or perform? (Everything reversible)

Q : Determine the power input to the heat pump

The energy generated within the house from people, lights, and appliances amounts to 4,500 kJ/h. For a COP of 2.5, determine the power input to the heat pump in kW.

Q : Determine the rate of entropy generation in heat exchanger

Cold water (c_p = 4.18 kJ/kg*C) leading to a shower enters a well-insulated, thin walled, double-pipe, counter-flow heat exchanger at 10 C at a rate of 0.95 kg/s and is heated to 70 C by hot water (c_p = 4.19 kJ/kg*C) that enters at 85 C at a rate

Q : What would be dislocation spacing be at the density

Based on inernal energy considerations, what dislocation density in Cu is needed to make the crystalline form of Cu unstable with respect to the liquid form? What would be dislocation spacing be at this density? Comment on your answer.

Q : Measured value of the current and hall voltage

The Hall-effect is used to determine the mobility of holes in a p-type silicon. Assume the bar resistivity is 20,000 ohm -cm the magnitude of Bz = 0.1 wb / m2, and d = w = 3 mm The measured value of the current and hall voltage are 100 mu A and 10

1928211

Questions
Asked

3,689

Active Tutors

1412969

Questions
Answered

Start Excelling in your courses, Ask a tutor for help and get answers for your problems !!

ask Question

Request for Solution File

Ask an Expert for Answer!!

Physics: How much work do we gain or perform

Reference No:- TGS0738151

Have a Question? (oR Write a Review)

Recent Questions Asked Physics

Q : How much is the mass rate for the outlet gases

Q : What is the power output of the turbine for a mass flow rate

Q : Determine a strain in the transverse direction

Q : What is the overall efficiency of the plant

Q : How much work do we gain or perform

Q : Determine the power input to the heat pump

Q : Determine the rate of entropy generation in heat exchanger

Q : What would be dislocation spacing be at the density

Q : Measured value of the current and hall voltage

Symptoms of post-severe stress disorder

Discuss patient presents with painful genital ulcers

Problem related to bypassing the screening protocol

Client with a history of chronic kidney disease is admitted

Did the cst handle this incident correctly

Patient presents with acute renal colic pain

Nurse is providing a tour of the labor and birth unit

Request for Solution File

Ask an Expert for Answer!!

Physics: How much work do we gain or perform

Reference No:- TGS0738151

Recent Questions Asked Physics

Q : How much is the mass rate for the outlet gases

Q : What is the power output of the turbine for a mass flow rate

Q : Determine a strain in the transverse direction

Q : What is the overall efficiency of the plant

Q : How much work do we gain or perform

Q : Determine the power input to the heat pump

Q : Determine the rate of entropy generation in heat exchanger

Q : What would be dislocation spacing be at the density

Q : Measured value of the current and hall voltage

Asked Questions