Response to the following :
1) Which of the following are examples of environmental technology?
Green building initiative
Conservation strategies
Fuel standards legislation
Coagulation and flocculation
Catalytic converter
2) Using the ideal gas law, determine how many molecules of oxygen and nitrogen molecules are in 1.0 liter of air at 22 C and 1.0 atm.
a million molecules of N2 and 200,000 molecules of O2
two trillion molecules of N2 and 500,000,000,000 molecules of O2
2.0 x 1022 molecules of N2 and 5 x 1022 molecules of O2
2.0 x 1022 molecules of N2 and 5 x 1021 molecules of O2
2.0 x 1023 molecules of N2 and 5 x 1022 molecules of O2
3) Which of the following statements are correct about hydraulic systems?
Always incorporate the use of pumps.
The main force for hydrostatic pressure is our atmosphere
The hydrostatic pressure is the same throughout a given area defined by height of water column
When you want SI units of pressure, you use the equation P = 0.43 x h
4) Which statement(s) is/are correct about any given water flow rate in closed pipes?
The velocity of flow is inversely proportional to the area of flow
The velocity of flow is inversely proportional to the diameter of pipes carrying the water
The calculations for water flow assume water is a compressible fluid
The flow rate can be expressed in ML/day.
5) Please examine the picture and check all the correct statements about the figure:
It is a schematic of soil vapor extraction
It is a schematic of air sparging
Pressurized air is injected into saturated zone at controlled pressures and volumes to force out volatile contaminants
It oxidizes contaminants to carbon dioxide and water
6) Please check all correct statements about the figure :
The solids on top are due to eutrophication
It is part of primary sewage treatment
It is part of secondary sewage treatment
We must continually bring in oxygen into the aerobic zone so that bacteria can metabolize carbon compounds into carbon dioxide and water
7) Remediation and control of radon in homes include:
Air stripping
Seal all floor cracks and joints to prevent radon entry
Ventilation inside of the home
Subslab ventilation
8) In general, three primary considerations in designing an effective control strategy in an industrial setting are:
environmental factors, systemic factors, and economic factors
environmental factors, ethical factors, and economic factors
environmental factors, engineering factors, and geopolitical factors
environmental factors, engineering factors, and economic factors
9) What statement(s) is (are) correct about the figure ?
It represents plans for water distribution
Pipe placement takes advantage of gravity
It is a gridiron system
Pumps are appropriately placed to minimize fluctuations in pressure
10) Which of the following are techniques that can be used to analyze gases, if the gases can be brought into solution?
Electrostatic precipitators
Activated carbon adsorption
Infrared absorption
Colorimetry
High-volume sampler
11) Which of the following options, the US EPA encourages or can be successfully used as an integrated waste management strategy for all waste streams?
recycling
reducing use of materials
open burning at abandoned backyards
source reduction composting
landfilling/disposal
12) Sources of industrial hazardous waste generation can be roughly divided into:
Large-quantity generators
Sewage
Small-quantity generators
Block of lead
Conditionally exempt small-quantity generators
13) Which of the following statements are correct about the figure ?
It shows three leachate collection zones
It is a schematic of a leachate collection system for a secure landfill.
It is a schematic of a leachate collection system for a sanitary landfill.
The compacted clay liner helps to collect leachate.
14) Please fill in each sentence with the most appropriate word or phrase .
______ is typically accomplished by bringing gases in contact with various aqueous solutions.
The solubility of gases ______ as the temperature of water increases.
Manning's formula is based upon _______ flow.
If you are given the mass of compound X and you need to determine the volume that mass will take up, you will need to find the _______ of compound X.
_______ occurs when molecules are physically attracted to surfaces and essentially sit on top of surfaces.
Water pollution control project typically use the ________ flow for design computations of drought flow.
The most common technology for capturing sulfur dioxide emissions is ________.
To determine how flow velocity changes when pipe size changes, we use the concept of continuity of flow. This concept applies to all liquids that are ____________.
Most _______ are not pathogenic, but its presence is used to indicate the presence of possible pathogens.
________ is a physical parameter is water that can interfere with disinfection processes and harbor microorganisms.
The dominant product (resulting molecule) of incineration is______ (for complete combustion).
Activated sludge and/or trickling filters are the most widely used technologies to achieve ___________ treatment.
_______ a measure of the amount of oxygen required to aerobically decompose organic matter in the water.
For a region of the world that has very cold winters and hot summers, you would most likely use ______ as sewer pipe materials.
Sampling frequencies and locations are stipulated in the _____ permit for wastewater effluent standards.
A physical process that can remediate both solid waste and hazardous waste is ________. This is also the least desirable of all possible waste remediation options, both for solid wastes and for hazardous wastes.
15) A solid waste becomes hazardous waste when the waste is listed on one of the four RCRA hazardous waste lists (F, K, P and U lists) pub lished in the Code of Federal Regulations (40 CFR 261) or possesses at least one of the following characteristics:
Corrosivity
Reactivity
Ignitability
Toxicity
16) The removal efficiency of an electrostatic precipitator (ESP) can be expressed mathematically as:
E = 100 * (1-e-wA/Q)
Where E = percent removal efficiency
e = base of natural logarithm, equal to 2.718
w= effective drift velocity
A=total surface area of plates
Q=gas flow rate through the unit
From the equation above, which of the following statements can be directly concluded?
The gas flow rate must be slow and uniform across each plate to obtain high removal efficiencies.
The removal efficiency will increase proportionately with increasing surface area of the electrostatic plates
Doubling the drift velocity will cut the efficiency by half
Increasing drift velocity will increase efficiency, but there is a physical limit to this as we need to maintain constant drift velocity
17) Check all correct statements about wet scrubbers
Scrubbers remove gases and vapors through adsorption
Scrubber liquids can react with some off-gas components
Scrubber are capable of removing particulates as well as gases and vapors
Scrubbers have low capital costs and low maintenance cost
18) Which of these are important factors to consider when determining if soil vapor extraction is appropriate for soil remediation of a hazardous waste spill?
Contaminants in the air
Soil type
Melting point of hazardous waste
Henry's constants of chemicals in hazardous waste
Vapor pressure of chemicals in hazardous waste
19) Which of the following are viable remediation options for soil heavily contaminated with lead and arsenic?[Please do not consider costs or practicality. Just what the technology is capable of doing.]
Soil vapor extraction
Soil washing
Solidification
Vitrification
20) Which of the following can be used for hazardous waste treatment?
Ion exchange
Composting
Incineration
Bioremediation
Solidification
21) Open channel flow is characteristic of flow in storm and sanitary sewers, streams, rivers, and canals. ____________ is typically used to analyze open channel flow systems.
Hazen-Williams Nomograph
Hazen-Williams Equation
Manning's Formula
Darcy's Law
22) Technologies to mitigate CO emissions include which of the following?
Increasing oxidation potential in off gas systems
Flocculation & filtration
Electrostatic precipitators
Catalytic converters
Precipitation
23) Noise pollution control technologies and personal protective equipment include which of the following?
Wave cancelling headphones
Zoning laws
Insulation around the source of noise
Off-gas systems
24) Match the word (s) or concept(s) with the appropriate phrase.
_____ are emitted directly into the air from a specific source such as a power plant.
_____ plays an important role with regards to atmospheric chemistry in both the troposphere and the stratosphere.
_______ is an example of a toxic air pollutant.
25) Please place the appropriate key word or phrase into the sentence that best describes it. Note that there are more key words and phrases than there are sentences.
____________ is a pipe, channel, or chimney from which pollutants are discharged directly into a body of water or the air.
_____________ are very important since they recycle all molecules and atoms in nature, allowing all wastes to be used by another species.
________ is the destruction of disease-causing microbes in water or sewage effluent, usually by the addition of chlorine, ozone, or UV radiation.
___________ is the pressure exerted by the vapor of a compound in equilibrium with the compound's pure phase at a given temperature.
______________is a biological process for treating garbage and/or sewage sludge, involving aerobic decomposition of organic waste under controlled conditions.
______ is a purification process used after secondary treatment aimed primarily at removing nutrients (i.e., nitrogen and phosphorus). It is also known as tertiary treatment.
The ____________ is the maximum concentration of a substance that will dissolve in water at a given temperature.
26) Which of the following statements are correct about the following equation: Qin = Qout?
It is correct for all fluids
It is called the continuity equation
The consequence of Q1 = Q2 is also that A1 × V1 = A2 × V2
The consequence of Q1 = Q2 is also the doubling of velocity with the doubling of pipe diameter.
27) Please fill in the blanks with the appropriate key word or phrase. Note that there are more key words and phrases than needed for this exercise.
A _____ network of pipes where water can circulate in interconnected loops, is the preferred pipeline layout.
The optimum coagulant dose is usually determined in the laboratory using a _______________.
Pipelines that carry both stormwater and sewage are called ______________.
________ are underground structures that provide access to cleaning, repair, sampling, and flow measurements of pipelines.
_________ is a mechanical cutting or shredding device often used for preliminary treatment of sewage.
_____________are not enforceable and are used as guidelines or suggestions.
_____________ is a water or wastewater sample obtained by mixing individual grab samples taken at regular time intervals over the sampling period.
28) Which of these conditions are likely to increase BOD?
Heat
Increased calcium content
Increased plant nutrients
increased amounts of U-238
Increased organics