Why medications include the hcl
Why do various medications include the hcl? Describe briefly?
Expert
HCl is a chemically abbreviated form of the Hydrochloride. This is the manner that the medications are put to the solid form. Most of the liquid or oral suspension formulas comprise HBr, hydro bromide. Several medications comprises Fumigate, some contain Male ate, and this is a medium to put the substances to or dilute them.
I) Sulphur dioxide (SO2) with a volumetric flow rate 5000cm3/s at 1 bar and 1000C is mixed with a second SO2 stream flowing at 2500cm3/s at 2 bar and 200C. The process occurs at steady state. You may assume ideal gas behaviour. For SO2 take the heat capacity at constant pressure to be CP/R = 3.267
Choose the right answer from following. An ideal solution was obtained by mixing methanol and ethanol. If the partial vapour pressure of methanol and ethanol are 2.619KPa and 4.556KPa respectively, the composition of the vapour (in terms of mole fraction) will be: (
In some two component, solid liquid systems, a eutectic mixture forms.Consider, now a two component system at some fixed pressure, where the temperature range treated is such as to include formation of one or more solid phases. A simple behavior is shown b
Chromium(III) hydroxide is highly insoluble in distilled water but dissolves readily in either acidic or basic solution. Briefly explain why the compound can dissolve in acidic or in basic but not in neutral solution. Write appropriate equations to support your answer.
Help me to go through this problem. Molecular weight of glucose is 180. A solution of glucose which contains 18 gms per litre is : (a) 2 molal (b) 1 molal (c) 0.1 molal (d)18 molal
Which one of the following non-ideal solutions shows the negative deviation: (a) CH3COCH3 + CS2 (b) C6H6 + CH3COCH3 (c) CCl4 + CHCl3
Unit of measurement- These are also some systems for units: (1)
Give me answer of this question. 5cm3 of acetone is added to 100cm3 of water, the vapour pressure of water over the solution: (a) It will be equal to the vapour pressure of pure water (b) It will be less than the vapour pressure of pure water
a) Air flowing at 1 m3/s enters an adiabatic compressor at 20°C and 1 bar. It exits at 200°C. The isentropic efficiency of the compressor is 80%. Calculate the exit pressure and the power required. b) Steam enter
Select the right answer of the question. If 18 gm of glucose (C6H12O6) is present in 1000 gm of an aqueous solution of glucose, it is said to be: (a)1 molal (b)1.1 molal (c)0.5 molal (d)0.1 molal
18,76,764
1960978 Asked
3,689
Active Tutors
1446248
Questions Answered
Start Excelling in your courses, Ask an Expert and get answers for your homework and assignments!!