--%>
Assignment Help - homework help

What is machine shop

Machine shop: A facility which employs machines to fabricate devices from stock raw materials or to change mechanisms based on given specifications. Also termed as "Back" Shops.

The general machines in a machine shop are a drilling machine, a lathe, a miller, a shaper or planer, grinding machine and so forth.

   Related Questions in Mechanical Engineering

  • Q : Welding rod 7018 State abbreviation of

    State abbreviation of the welding rod 7018?

    		•
  • Q : Bernoulli's equation From Bernoulli's

    From Bernoulli's equation we know that presure head + velocity head at inlet and outlet header is same. If so  what is ' W' then in the equation ?

    		•
  • Q : Problem on degree of freedom Draw a

    Draw a frequency-response curves for a damped single degree of freedom system subjected to a harmonic excitation under three different damping ratios. System has a natural frequency of ωn as the forcing frequency of the excitation is ω. Describe

    		•
  • Q : Poissons Ratio Out of

    Out of Rubber/Steel/Wood, which have higher Poissons Ratio?

    		•
  • Q : P11 and P12 Pipes Explain difference

    Explain difference between the P11 and P12 Pipes?

    		•
  • Q : Define spinning jenny Spinning jenny:

    Spinning jenny: It is a multi-spool spinning wheel. It was invented in the year 1764 by James Hargreaves in Stanhill, close to Blackburn, Lancashire in the north west of England (though Thomas Highs is another candidate recognized as inventor).

    		•
  • Q : Solar Thermal systems Explain the two

    Explain the two Solar thermal DHW and Solar DHW Solar thermal systems n brief?

    		•
  • Q : Problem on discharge of water In the

    In the below system, d = 6 in., D = 12 in., Δz1 = 6 ft, and Δz2 = 12 ft. The discharge of water in the given system is 10 cfs. Is the machine a turbine or a pump ? Determine the pressures at points A and B? Neglect head losses. Suppos

    		•
  • Q : Problem related to mass flow rate Water

    Water flows via a control volume as illustrated in the figure below. At Section (1) the diameter is 40 mm and the velocity profile is given by the V(r) = 10 (4 – r2) m/s, here r is the  distance from the centerline. At Section (2) the mass flow r

    		•
  • Q : 01 a vaccume guage connected to chamber

    a vaccume guage connected to chamber 40kpa at location where atmospheri pressure is100kpa .determine absolute pressure

    		•