--%>
Assignment Help - homework help

What is Cotter joint

Cotter joint: These kinds of joints are employed to connect two rods that are under compressive or tensile stress. The ends of rods are in the way of a socket and shaft which fit altogether and the cotter is driven into a slot which is common to both pieces drawing them firmly altogether. The tensile strength of the steel is in proportion to the strength required to offset the stress on the material split by the number of joints employed.   

   Related Questions in Mechanical Engineering

  • Q : Static and Dynamic load What are Static

    What are Static and Dynamic load and what are their significant dynamic effects?

    		•
  • Q : Mechanical Systems Reliability -

    Mechanical Systems Reliability, MP3701 Your assignment must be submitted electronically via eLe

    		•
  • Q : Problem on Ideal gas process A) Air at

    A) Air at 4MPa and 3000C enters a will insulated turbine operating at steady state with negligible velocity. The air expands to an exit pressure of 100KPa. The exit velocity and temperature are 90 m/s and 1000C respectively. The diameter of the e

    		•
  • Q : Undamped single degree of freedom (a)

    (a) The response for an undamped single degree of freedom system under free vibration is given as where ωn is the natural frequency and A and B are unknown that can be determined from the initial conditions. The response 

    		•
  • Q : Maintenance in Product design

    Maintenance: How frequently and easily the product is to be maintained must be specified. A photocopier shouldn't require a service call from a technician just to add toner. If the product is to be maintenance free, then costs may be increased due to

    		•
  • Q : Modal Combination Rules What are the

    What are the Modal Combination Rules in order to determine the peak value of the total response?

    		•
  • Q : Synchronous generator & Generating units

    Question 1: Three generating units operating in parallel at 60 Hz have rating of 300, 500, and 600    MW and have speed-droop characteristics of 5, 4, and 3%, respectively. Due to a change in load, a

    		•
  • Q : Dynamic model for the paper machine

    Explain and derive the Dynamic model for the paper machine headbox?

    		•
  • Q : Rated Speed and Economic Speed Explain

    Explain difference between the Rated Speed and Economic Speed?

    		•
  • Q : Problem on degree of freedom Draw a

    Draw a frequency-response curves for a damped single degree of freedom system subjected to a harmonic excitation under three different damping ratios. System has a natural frequency of ωn as the forcing frequency of the excitation is ω. Describe

    		•