--%>
Assignment Help - homework help

Safety in Product design specification

Safety: The specifications should state the possible abuse and misuse the product might be subjected to. Warning labels and instructions on safe operation of the product should be given. The designer can be held accountable for any accidents that might take place due to poor product design.

   Related Questions in Mechanical Engineering

  • Q : Advantages and disadvantages of using

    Explain advantages and disadvantages of using the LPG in Car?

    		•
  • Q : Excitation of Modes in Fiber A

    A multimode fiber is used to couple light into a single mode fiber. Both fibers have the same total diameter. Explain the coupling. Use equations, MATLAB, etc. if necessary. If an LED is used to excite a single mode fiber, explain the coupling of light to the fiber? U

    		•
  • Q : Problem on pressure rise of a water tank

    The water level in a tank is about 20 m above the ground. A hose is joined to the bottom of the tank, and the nozzle in the end of the hose is pointed to straight up. The tank is at sea level, and the water surface is open to the environment. In the line leading from

    		•
  • Q : Hard links Explain the term hard links?

    Explain the term hard links?

    		•
  • Q : P11 and P12 Pipes Explain difference

    Explain difference between the P11 and P12 Pipes?

    		•
  • Q : Anti-Friction and Journal Bearing

    Explain difference between the Anti-Friction Bearing and the Journal Bearing?

    		•
  • Q : Problem on displacement response time

    (i) Formulate the equation of motion for the system shown in Figure below. List two assumptions made in this formulation. (ii) Find the response of this system at t = 3s. The system begins with the displacement of 5 cm and velocity

    		•
  • Q : Cetane Number and Octane Number

    Describe the term Cetane Number and the Octane Number?

    		•
  • Q : Value Engineering The value engineering

    The value engineering method focuses on functional values, and aims to increase the difference between the cost and value of a product: by lowering cost and/or adding value. In many cases, the emphasis is simply on reducing costs, and the design effor

    		•
  • Q : Poissons Ratio Out of

    Out of Rubber/Steel/Wood, which have higher Poissons Ratio?

    		•