--%>
Assignment Help - homework help

Quantity in Product design specification

Quantity: The total quantity of the product predicted and, more importantly, the production rates and batch sizes needed, should be specified. This will have implications for the types of manufacturing equipment and work organization necessary. It will also affect production costs. Generally, as the number of units being made increases, the cost per unit decreases. (Cost of equipment is spread out over more units, suppliers usually offer bulk discounts, and so forth.)

   Related Questions in Mechanical Engineering

  • Q : What is pneumatic system Pneumatic

    Pneumatic system is a system which employs air to power something. For illustration, have you seen the tube systems at the bank drive-up tellers? Air is employed to push the tubes back and forth from the teller to customer.

    Q : What is wrap-around Wrap-around : The

    Wrap-around: The main aim of a wrap-a-round is to make a straight line about a pipe to help in cutting the pipe to its appropriate length. It is employed mostly as a straight edge or a template.   

    		•
  • Q : Arena simulation Are you able to modify

    Are you able to modify the attached [HW4-4-1sawModifiedInstructorTemplate] with the information below for this assignment? Modify the attached exercise by adding agent breaks. The 16 hours are divided into two 8-hour shifts. Agent

    		•
  • Q : Lubricating oil in turbines Except the

    Except the lubrication, explain the other two functions of the lubricating oil in some of the turbines?

    		•
  • Q : Carburetion A carburetor's primary

    A carburetor's primary function is to mix proper proportions is?

    		•
  • Q : Synchronous generator & Generating units

    Question 1: Three generating units operating in parallel at 60 Hz have rating of 300, 500, and 600    MW and have speed-droop characteristics of 5, 4, and 3%, respectively. Due to a change in load, a

    		•
  • Q : Problem on discharge head loss Water is

    Water is draining from the tank A to tank B. The elevation difference among the two tanks is 10 m. The pipe joining the two tanks has a sudden-expansion section as shown below. The cross-sectional area of the pipe from A is 8 cm2, and the area of the pipe f

    		•
  • Q : Measuring the Temperature in Wet Bulb

    Explain phenomenon to measure the Temperature in Wet Bulb Thermometer?

    		•
  • Q : How do you repair a hydraulic jack How

    How do you repair a hydraulic jack?

    		•
  • Q : Efficient use of waste heat and

    Efficient use of waste heat and renewable heat sources 1. Describe how you might recover heat from (a) a process exhaust gas stream (e.g. from an oven) and (b) a process warm water stream (e.

    		•