--%>
Assignment Help - homework help

Powder Technology

Explain the term Powder Technology?

E

Expert

Verified

Powder technology is defined as one of the ways of forming the bearing material. Within this method metals such as bronze, Al, Fe are mixed and compressed in order to form an alloy.

   Related Questions in Mechanical Engineering

  • Q : Safe turbine operation For safe turbine

    For safe turbine operation how many governors are generally required and Why?

    		•
  • Q : Define Mechanism Mechanism : The

    Mechanism: The mechanism is a system of moving parts which changes an input motion and force into the desired output force and motion.

    		•
  • Q : 01 a vaccume guage connected to chamber

    a vaccume guage connected to chamber 40kpa at location where atmospheri pressure is100kpa .determine absolute pressure

    		•
  • Q : Aim of an airspeed indicator in aircraft

    What is the main aim of an airspeed indicator in aircraft?

    		•
  • Q : Problem on mechanical efficiency of the

    The oil pump is drawing 25 kW of electric power while pumping oil with ρ = 860 kg/m3 at a rate of 0.1 m3/s. The inlet and outlet diameters of the pipe are of 8 cm and 12 cm, respectively. When the pressure rise of oil in the pump is measured to be 250 k

    		•
  • Q : Problem on Ideal gas process A) Air at

    A) Air at 4MPa and 3000C enters a will insulated turbine operating at steady state with negligible velocity. The air expands to an exit pressure of 100KPa. The exit velocity and temperature are 90 m/s and 1000C respectively. The diameter of the e

    		•
  • Q : Problem on displacement response time

    (i) Formulate the equation of motion for the system shown in Figure below. List two assumptions made in this formulation. (ii) Find the response of this system at t = 3s. The system begins with the displacement of 5 cm and velocity

    		•
  • Q : Efficient use of waste heat and

    Efficient use of waste heat and renewable heat sources 1. Describe how you might recover heat from (a) a process exhaust gas stream (e.g. from an oven) and (b) a process warm water stream (e.

    		•
  • Q : Excitation of Modes in Fiber A

    A multimode fiber is used to couple light into a single mode fiber. Both fibers have the same total diameter. Explain the coupling. Use equations, MATLAB, etc. if necessary. If an LED is used to excite a single mode fiber, explain the coupling of light to the fiber? U

    		•
  • Q : Product performance in Product design

    Product performance: Depending on the product, this may take many forms. Speed, loads to be withstood, number of work cycles, and intermittent or continuous working are some examples of considerations. 

    		•