--%>
Assignment Help - homework help

petroleum technology

theories for the origin of petroleum, methods for detection of petroleum deposits, fractional distillation

   Related Questions in Mechanical Engineering

  • Q : Difference between PLC and Logic Card

    Difference between PLC and Logic Card: There is technically no difference. Both are logic controller utilized for several applications and in PLC has it's own internal memory (compared to Logic card).

  • Q : Problem on flow rates Water flows at 40

    Water flows at 40 m/s from the jet of area of cross-section of 0.008 m2 on to a flat plate as shown in the figure. Determine the force F normal to the plate, and also the flow rates out of the plate.

    Q : Problem related to mass flow rate Water

    Water flows via a control volume as illustrated in the figure below. At Section (1) the diameter is 40 mm and the velocity profile is given by the V(r) = 10 (4 – r2) m/s, here r is the  distance from the centerline. At Section (2) the mass flow r

    		•
  • Q : Cetane Number and Octane Number

    Describe the term Cetane Number and the Octane Number?

    		•
  • Q : Undamped single degree of freedom (a)

    (a) The response for an undamped single degree of freedom system under free vibration is given as where ωn is the natural frequency and A and B are unknown that can be determined from the initial conditions. The response 

    		•
  • Q : Ergonomics in product design

    Ergonomics: This is concerned with how easy (comfort, complexity) the product is to use by the targeted market. Physical human dimensions must be considered when designing the driver's seating, instruments, and controls in a car. Slight variations bet

    		•
  • Q : What is machine shop Machine shop : A

    Machine shop: A facility which employs machines to fabricate devices from stock raw materials or to change mechanisms based on given specifications. Also termed as "Back" Shops. The general machines in a machine sh

    		•
  • Q : Aerospace Computational Techniques -

    Hello, I have a programming assignment that incorporates aerodynamics. I was wondering if it is possible to program the following assignment. If not, what would be the aerodynamic formulas required to do so. Thanks.

    		•
  • Q : Problem related to pressure gauge Water

    Water flowing via the vertical pipe is illustrated below. Compute the required pipe diameter for the smaller pipe,‘d’,  given that the two pressure gauges read similar value.

    Q : State Concurrent Engineering Concurrent

    Concurrent Engineering has happened primarily as a result of the need to shorten product development times, but improving product quality and reducing product life-cycle costs are important considerations. Some companies have even gone to the extent o

    		•