--%>
Assignment Help - homework help

P11 and P12 Pipes

Explain difference between the P11 and P12 Pipes?

E

Expert

Verified

a) P11 chromium molybdenum composition which is 1% of chromium and 1/4% of molybdenum.

b) P12 chromium molybdenum composition which is 1% of the chromium and 2% of the molybdenum.

   Related Questions in Mechanical Engineering

  • Q : Deareator In Thermal Power Plant, Why

    In Thermal Power Plant, Why Deareator is placed at the Height?

    		•
  • Q : Measuring the Temperature in Wet Bulb

    Explain phenomenon to measure the Temperature in Wet Bulb Thermometer?

    		•
  • Q : Problem on flow rates Water flows at 40

    Water flows at 40 m/s from the jet of area of cross-section of 0.008 m2 on to a flat plate as shown in the figure. Determine the force F normal to the plate, and also the flow rates out of the plate.

    Q : Calculating liquid composition There

    There is a 35% MeOH/water mix to feed to a flash at 100 Ib- mole /hr and 1 atm. We want a vapour composition of 60 % MeOH. What does the vapour flow rate need to be? What is the liquid composition? Give the equation of the operation line?

    Q : Problem on magnitude of force A

    A horizontal pipe of dimension 540 mm diameter carrying 0.6 m3/s splits into two horizontal pipes of 300 mm diameter with 60% of the flow and another of 150 mm diameter with 40% of the flow. Find out the magnitude and direction of the force

  • Q : Safe turbine operation For safe turbine

    For safe turbine operation how many governors are generally required and Why?

    		•
  • Q : Petroleum technology theories for the

    theories for the origin of petroleum, methods for detection of petroleum deposits, fractional distillation

    		•
  • Q : Problem on damping coefficient Vertical

    Vertical suspension system of a car can be modeled as single degree of the freedom system. Consider that the car with mass m consists of four shock absorbers with equal stiffness and damping of k and c, corresspondingly: (a) Due to

    		•
  • Q : Bearing number ti Diameter of inner and

    Specify how the Bearing number ti Diameter of the inner and outer can be calculated?

    		•
  • Q : Problem on basic process of Arena

    Are you able to assist with these two assignments in Arena simulation below? You can use the Basic Process instead of Blocks and Elements.An office of state license bureau has two types of arrivals. Individuals interested in purchasing new plates are chara

    		•