--%>

Memory system and memory less system

Explain what is meant by the memory system and the memory less system?

E

Expert

Verified

If system’s output signal at certain time depends upon the past values of input signal then the system is said to be memory. Circuit with inductors capacitors are examples of the memory system.

If output at certain time depends upon the current values of the input signal then the system is said to be memory less system. An electronic circuit with the resistors is considered as an example for the memory less system.

   Related Questions in Electrical Engineering

  • Q : Illustrates the some DSP used within

    Illustrates the some DSP used within embedded systems? Answer: Some DSP used in the embedded system are: TMS320Cxx, SHARC and 56

  • Q : Explain various models used in design

    Explain the various models used into the design of an embedded system?

  • Q : What is component testing What is meant

    What is meant by the component testing?

  • Q : Explain about iterative algorithm

    Explain about iterative algorithm.

  • Q : Calculate the output voltage of MOS

    The transfer characteristic of a particular resistively loaded MOS transistor inverter is demonstrated below in figure. Express an expression for the co-ordinates of the point, (ViA,VOA) upon this characteristic whether VO = Vi

  • Q : Find out the value and manufacturing

    Find out the value and manufacturing tolerance of resistors within the E12 series containing the colour codes printed upon then from left to right as given below:

  • Q : Problem on electric power The sketch

    The sketch illustrates a common consumer product termed as Water Pik. This device uses a motor to drive a piston pump that produces a jet of water (diameter d = 3 mm, temperature T = 10 °C) with a speed of 25 m/s. Find out the minimum electric power in watts which is needed by the device.

  • Q : Estimate phase and gain margins of

    An operational amplifier contains an open-loop transfer function specified as: A(?) = 104/([1 + j(?/31.4x106)][1 + j(?/314x 106)]) The op-amp is

  • Q : Estimate minimum value of input

    The network demonstrated in figure presents the input of a biomedical amplifier, now the input impedance is seem purely resistive, R and a capacitor, C, is used to block dc.

    Q : Meaning of half-duplex and full-duplex

    Illustrate the meaning of the term half-duplex and full-duplex communication? Describe in brief.