--%>
Assignment Help - homework help

Mechanical design for manufacturing

A stone quarry in a remote part of the world requires that stone blocks of 3 cubic feet in volume be moved up a 50 ft long ramp which is inclined at 30 degrees. Since the location is remote, the blocks must be moved usng human power. On a continuous basis, human power can sustain an output of 0.25 HP. The top of the ramp is even with the deck of the truck which will transport the blocks.

Design a system which will provide this function and state clearly how many blocks can be moved out of the quarry if the system is powered by a single worker.

Show your assumptions, calculations and sketches.

   Related Questions in Mechanical Engineering

  • Q : Problem on discharge of water In the

    In the below system, d = 6 in., D = 12 in., Δz1 = 6 ft, and Δz2 = 12 ft. The discharge of water in the given system is 10 cfs. Is the machine a turbine or a pump ? Determine the pressures at points A and B? Neglect head losses. Suppos

    		•
  • Q : Welding rod 7018 State abbreviation of

    State abbreviation of the welding rod 7018?

    		•
  • Q : Convection Heat Transfer Please Solve

    Please Solve this problem Step by step, and the question is in the images.

    		•
  • Q : Bearing number ti Diameter of inner and

    Specify how the Bearing number ti Diameter of the inner and outer can be calculated?

    		•
  • Q : Causes and consequences of dynamic

    Discuss the causes and consequences of dynamic loading on structures based on two real examples. Support your discussion with proper diagrams or sketches. Your discussion shall include the time and location of the event, type and source of dynamic loa

    		•
  • Q : Brazing and Welding Differentiate the

    Differentiate the term Brazing and Welding?

    		•
  • Q : Difference between pressure vessel &

    Difference between pressure vessel & column: The Pressure vessels (cylinder or tank) are utilized to store fluids under pressure. If the pressure vessel are design in the form of column to separate the gas at u

    		•
  • Q : Problem on flow rates Water flows at 40

    Water flows at 40 m/s from the jet of area of cross-section of 0.008 m2 on to a flat plate as shown in the figure. Determine the force F normal to the plate, and also the flow rates out of the plate.

    Q : Problem on Ideal gas process A) Air at

    A) Air at 4MPa and 3000C enters a will insulated turbine operating at steady state with negligible velocity. The air expands to an exit pressure of 100KPa. The exit velocity and temperature are 90 m/s and 1000C respectively. The diameter of the e

    		•
  • Q : What is Cotter joint Cotter joint :

    Cotter joint: These kinds of joints are employed to connect two rods that are under compressive or tensile stress. The ends of rods are in the way of a socket and shaft which fit altogether and the cotter is driven into a slot which is common to both

    		•