--%>
Assignment Help - homework help

Instructions supported by 8051

Describe the various groups of the instructions that is supported by 8051?

E

Expert

Verified

a) Arithmetic Group

b) Data Transfer Group

c) Branching Group

d) Logical Group

e) Bit manipulation Group

   Related Questions in Electrical Engineering

  • Q : Find out impedance in form of phase and

    Find out the impedance of the network demonstrated below as considered by the voltage source, V1, while operating at a frequency of 50Hz. Illustrates this in the form of phase and magnitude. In addition, determine the current drawn from the source by the ne

    		•
  • Q : Significance of Cogeneration

    Significance of Cogeneration: It decreases energy costs and green house gas emissions usually by upto two-third. In addition to decreasing in cost, cogeneration too rises resource utilization. It provides major economic and environmental facilities si

    		•
  • Q : Define the term CAN bus its used Define

    Define the term CAN bus its used?

    		•
  • Q : Complexity of deriving test of circuit

    Explain the factors which measures the complexity of deriving the test of circuit?

    		•
  • Q : Illustrates about the pseudo-code

    Illustrates about the pseudo-code?

    		•
  • Q : Calculate torque developed in pump and

    The motor within an automobile water pump draws a power of 10 Watt from the 12Volt battery. The permanent magnets of the stator produce a complete magnetic flux of 0.05Wb. The rotor former of a length of 8cm, a diameter of 5cm and the armature winding has 20 conductin

    		•
  • Q : Solid state circuits Explain briefly

    Explain briefly the solid state circuits employed for the stator voltage control of induction motor derives.

    		•
  • Q : Jump statement Explain about the jump

    Explain about the jump statement?

    		•
  • Q : Estimate maximum tolerable load

    In the capacitively loaded individual transistor inverter demonstrated below, the input voltage is switched abruptly from VCC to 0Volt at time t = 0. In that case the transistor is assumed to function as an ideal change, draw the waveform of the output volt

    		•
  • Q : Report on designing and simulating a

    Objective: To present a consultant report for designing and simulating a control system. Define a practical engineering plant which would feature similar dynamical behaviour to the theoretical dynamics given in the

    		•