--%>
Assignment Help - homework help

Handling MOS devices

Specify all the precautions which are to be taken while handling the MOS devices?

E

Expert

Verified

Precautions that are to be taken are listed as follows:

a) Individuals that are handling MOSFET devices and their workplaces must be grounded.

b) Whenever a chip is out of the circuit, it must be inserted within the special conductive foam which efficiently shorts all pins alltogether.

c) Within the system design, all the unused pins must be attached to the ground or to the supply voltage.

d) Circuits must have power supplied before connecting or dis-connecting the low impedance signal sources just like pulse generators.

   Related Questions in Electrical Engineering

  • Q : Characteristics of 8051 micro

    Explain the characteristics of the 8051 micro controllers?

    		•
  • Q : Problem on Circuit analysis A student

    A student builds the circuit shown below. As it is the circuits contains two major mistakes. Your task is to identify these mistakes and suggest a solution for each. When identifying solutions explain for each case where the mistake is and why the circuit will not wor

    		•
  • Q : Properties of FIR filter Explain some

    Explain some of the properties of FIR filter? Specify the condition upon the FIR sequence h (n) which are to be imposed and order that this filter is termed as the liner phase filter?

    		•
  • Q : Calculate torque developed in pump and

    The motor within an automobile water pump draws a power of 10 Watt from the 12Volt battery. The permanent magnets of the stator produce a complete magnetic flux of 0.05Wb. The rotor former of a length of 8cm, a diameter of 5cm and the armature winding has 20 conductin

    		•
  • Q : What is IDMT relay Describe the term

    Describe the term IDMT relay?

    		•
  • Q : Calculate the maximum thickness of the

    Excess minority carriers are injected within a thin slice of doped semiconductor of uniform cross-sectional region and are permitted to diffuse across the material. There diffusion coefficient for the material is 50cm2s-1 as well as the minority

    		•
  • Q : Characteristics of ECL Explain some of

    Explain some of the characteristics of ECL?

    		•
  • Q : Checksum generation List out the steps

    List out the steps which are followed in the checksum generator?

    		•
  • Q : What are the kinds of embedded system

    What are the kinds of embedded system? Answer: The embedded systems are given below: Small scale embedded systems, Medium scale

    		•
  • Q : Find current in conductor of permanent

    The pole faces of a permanent magnet measure 100 millimeter high by 200mm wide. This is needed to acquire an acceleration of 10ms-2 of a single length of current-carrying conductor that weighs 250gm-1 and is positioned vertically inside the magnetic field, passing horizontal

    		•