--%>
Assignment Help - homework help

Find out reactance of values of capacitor at frequencies

Find out the reactance of the values of capacitor at the frequencies given below. Then find out the value of inductor in each case that will provide similar reactance as the capacitor as follows:.

(a)  3.3 µF at 50Hz

(b)  12nF at 20kHz and

(c)  4.7pf at 250MHz.

   Related Questions in Electrical Engineering

  • Q : Application Specific System processors

    Illustrates the Application Specific System processors used in the embedded system? Answer: An application specific system processor is utilized as an additional pro

    		•
  • Q : Answering some questions hi, read that

    hi, read that questions that i attached, could you answer all of them.

    		•
  • Q : Function of port 0 of 8051 Explain the

    Explain the special function of the port 0 of 8051?

    		•
  • Q : Power can you solve the attached

    can you solve the attached problems?? the deadline 29/4/2014 10am

    		•
  • Q : Wave winding in wave winding if dummy

    in wave winding if dummy coil is present then how we specified connection...and also how we calculate the no of conductor in one pole ..

    		•
  • Q : Result of excess voltage to CMOS devices

    Describe what will happen when excess gate voltage is provided to the CMOS devices?

    		•
  • Q : Establish output voltage as supply

    A bipolar diode based logic circuit is demonstrated in given figure. Establish the output voltage as the supply voltage, VCC, as well as the circuit parameters for all combinations of input logic levels along with VH = VCC and VL = 0V. Draw waveforms demonstrating the input

    		•
  • Q : Find out outer dimension required to

    A high-wattage resistor for employ in a dc power supply is formed through depositing Carbon containing a square cross-section to an insulated former containing a cylindrical shape along with a diameter of 2.5 millimetres. A section with the component is demonstrat

    		•
  • Q : Problem on interfacing a microcontroller

    We will be using a bipolar stepper motor to control the motion of the cart. 1. How do you interface a microcontroller to a motor? Can you just connect the pins? 2. What are H-br

    		•
  • Q : Find out the impedance Find out the

    Find out the impedance of the network demonstrated below as considered by the voltage source, V1, while operating at a frequency of 1 kHz. Express it in the form of phase and magnitude. Moreover, find the current drawn by the source by the network in simila

    		•