--%>
Assignment Help - homework help

Explain steam turbine diaphragm

Steam turbine diaphragm: Steam turbine includes of phases, number and size of the phases depends on the break horse-power of the turbine.

The phase has set of moving and fixed blades. Moving blades are joined to the rotor whereas the stationary blades are termed as Diaphragm.

Diaphragm guides the steam to glide above the moving blades for generating rotary motion.

   Related Questions in Mechanical Engineering

  • Q : Efficient use of waste heat and

    Efficient use of waste heat and renewable heat sources 1. Describe how you might recover heat from (a) a process exhaust gas stream (e.g. from an oven) and (b) a process warm water stream (e.

    		•
  • Q : Poissons Ratio Out of

    Out of Rubber/Steel/Wood, which have higher Poissons Ratio?

    		•
  • Q : Difference between PLC and Logic Card

    Difference between PLC and Logic Card: There is technically no difference. Both are logic controller utilized for several applications and in PLC has it's own internal memory (compared to Logic card).

  • Q : What is cotter joint Explain what is

    Explain what is meant by the Cotter joint?

    		•
  • Q : Problem on motion of the system (a) A

    (a) A plane moving at a constant velocity, V, crashes into a building as shown in figure below. Due to the design against plane crash of that building, neither major damage nor explosion occurs but the building vibrates after the crash. Assuming that the building can

    		•
  • Q : High Discharge pump Why Centrifugal

    Why Centrifugal Pump is known as the High Discharge pump?

    		•
  • Q : Difference between pressure vessel &

    Difference between pressure vessel & column: The Pressure vessels (cylinder or tank) are utilized to store fluids under pressure. If the pressure vessel are design in the form of column to separate the gas at u

    		•
  • Q : Safe turbine operation For safe turbine

    For safe turbine operation how many governors are generally required and Why?

    		•
  • Q : State Concurrent Engineering Concurrent

    Concurrent Engineering has happened primarily as a result of the need to shorten product development times, but improving product quality and reducing product life-cycle costs are important considerations. Some companies have even gone to the extent o

    		•
  • Q : Safety in Product design specification

    Safety: The specifications should state the possible abuse and misuse the product might be subjected to. Warning labels and instructions on safe operation of the product should be given. The designer can be held accountable for any accidents that migh

    		•