Elementary signals

Explain the term elementary signals and list them?

E

Expert

Verified

Elementary signals are considered as building block for the generation of more complex signals. They are significant in their own right, in that they can be used to model several physical signals which happen in nature.

There exist five elementary signals as given below:

a) Unit step function

b) Exponential function

c) Unit impulse function Ramp function

d) Sinusoidal function

   Related Questions in Electrical Engineering

  • Q : Describe rationale of design approach

    A driver circuit is needed to operate the solenoid that controls the flow-valve within an effluent disposal system. There valve opens while the solenoid is activated upon receipt of an active-high input control pulse, consisting of a minimum level of ½ of the s

  • Q : Circuits RLC resonant pls solve the

    pls solve the problems in the attached file pls provide all steps .mention all required laws applied while solving for capacitor value take 1989 nano farads for inductors value take 1708 micro henry

  • Q : Explain term meta-stability Explain the

    Explain the term meta-stability? When and why it may occur? Explain several ways in order to avoid this?

  • Q : Addressing modes supported by C5X

    Explain the addressing modes which are supported by the C5X processors?

  • Q : Define Cogeneration Cogeneration is a

    Cogeneration is a very high efficiency energy system which generates both electricity (or mechanical energy) and valuable heat from the single fuel source. Cogeneration is some times termed as combined heat and not only produces power however also giv

  • Q : What is meta-learning Explain the term

    Explain the term meta-learning. Describe in detail.

  • Q : Mode coupling condition A multimode

    A multimode fiber is employed to couple light into a single mode fiber. Both of the fibers have the similar total diameter. Explain the coupling in brief. Use equations, MATLAB, and so on if necessary.

  • Q : What is logic family What do you mean

    What do you mean by logic family? Describe it in detail.

  • Q : High speed TTL and low power TTL State

    State some of the differences between high speed TTL and low power TTL?

  • Q : Size of inverters Explain the

    Explain the phenomenon of gradually increasing the size of the inverters in the buffer design while trying to run high capacitive load? Why not provide the output of circuit into one large inverter?

©TutorsGlobe All rights reserved 2022-2023.