--%>

Describe Process Flow Diagram

Process Flow Diagram: A Process Flow Diagram or System Flow Diagram exhibits the relationships among the main components in the system. It too has fundamental information regarding the material balance for the process.

   Related Questions in Mechanical Engineering

  • Q : Measuring the Temperature in Wet Bulb

    Explain phenomenon to measure the Temperature in Wet Bulb Thermometer?

  • Q : Diesel Engine What will happen if the

    What will happen if the gasoline is used within the Diesel Engine, whether the Siesel Engine will work or not?

  • Q : Undamped single degree of freedom (a)

    (a) The response for an undamped single degree of freedom system under free vibration is given as where ωn is the natural frequency and A and B are unknown that can be determined from the initial conditions. The response 

  • Q : Problem on displacement response time

    (i) Formulate the equation of motion for the system shown in Figure below. List two assumptions made in this formulation. (ii) Find the response of this system at t = 3s. The system begins with the displacement of 5 cm and velocity

  • Q : Problem on Ideal gas process A) Air at

    A) Air at 4MPa and 3000C enters a will insulated turbine operating at steady state with negligible velocity. The air expands to an exit pressure of 100KPa. The exit velocity and temperature are 90 m/s and 1000C respectively. The diameter of the e

  • Q : What is cotter joint Explain what is

    Explain what is meant by the Cotter joint?

  • Q : Poissons Ratio Out of

    Out of Rubber/Steel/Wood, which have higher Poissons Ratio?

  • Q : What is Cotter joint Cotter joint :

    Cotter joint: These kinds of joints are employed to connect two rods that are under compressive or tensile stress. The ends of rods are in the way of a socket and shaft which fit altogether and the cotter is driven into a slot which is common to both

  • Q : Problem on discharge of water In the

    In the below system, d = 6 in., D = 12 in., Δz1 = 6 ft, and Δz2 = 12 ft. The discharge of water in the given system is 10 cfs. Is the machine a turbine or a pump ? Determine the pressures at points A and B? Neglect head losses. Suppos

  • Q : Gasoline in Diesel Engine If the

    If the gasoline is used in the Diesel engine explain whether the Diesel engine will work?