--%>

Define Laue pattern

Laue pattern (M. von Laue): The pattern generated on a photographic film whenever high-frequency electromagnetic waves (like x-rays) are fired at the crystalline solid.

   Related Questions in Physics

  • Q : What is Reflection law Reflection law :

    Reflection law: For a wave-front intersecting a reflecting surface, the angle of incidence is equivalent to the angle of reflection, in the similar plane stated by the ray of incidence and the normal.

  • Q : What is Edwards-Casimir quantum vacuum

    What is Edwards-Casimir quantum vacuum drive: The hypothetical drive developing the peculiarities of quantum mechanics by restricting permitting wavelengths of the virtual photons on one side of the drive (that is the bow of the ship); the pressure pr

  • Q : Current through resistors How do I find

    How do I find out a maximum current flowing through a resistor with just the resistance of the resistor and it's power rating?

  • Q : Kinematics why rockets are also called

    why rockets are also called as projectile

  • Q : Explain Joules laws and Joule's

    Joule's laws (J.P. Joule) Joule's first law: The heat Q generated whenever a current I flows via a resistance R for a specified time t is specified by: Q = I2

  • Q : Problem on dot equivalent Obtain the

    Obtain the “dot” equivalent for the circuit shown below and use it to find the equivalent inductive reactance. 2141_dot.jpg

    Q : Ampere's law Explain  Ampere's law?  

    Explain Ampere's law?   Ampere's law (A.M. Ampere):

  • Q : Explain Ohms law Ohm's law (G. Ohm;

    Ohm's law (G. Ohm; 1827): The ratio of the potential difference among the ends of a conductor to the current flowing via it is constant; the constant of proportionality is termed as the resistance, and is distinct for different materials.

  • Q : Continuity of equation or Equation of

    Define Equation of continuity or Continuity of equation: An equation that states that a fluid flowing via a pipe flows at a rate that is inversely proportional to the cross-sectional region of the pipe. That is, when the pipe constric

  • Q : Problem on multi level TDM Ten sources,

    Ten sources, six with a bit rate of 200 Kbps and four with a bit rate of 400Kbps are to be combined using multi level TDM  with no sync bits. Answer the questions below about the final phase of multiplexing: a