--%>

Current through resistors

How do I find out a maximum current flowing through a resistor with just the resistance of the resistor and it's power rating?

   Related Questions in Physics

  • Q : Kirchhoffs rules or Loop rule or Point

    Explain Kirchhoff's rules or Kirchhoff's Loop rule and Point rule? Kirchhoff's rules (G.R. Kirchhoff) <

  • Q : What it means of Aberration Defining 

    Defining Aberration: The obvious change in the position of a light-emitting object due to the fidelity of the speed of light and the

  • Q : Dynamic strain aging and the strain

    What is the basic difference among the dynamic strain aging and the strain aging?

  • Q : What is balmer series Balmer series (J.

    Balmer series (J. Balmer; 1885): An equation that explains the emission spectrum of hydrogen whenever an electron is jumping to the next orbital; four of the lines are in visible spectrum, and the remainder (residue) are in the ultraviolet.

  • Q : Problem on multi level TDM Ten sources,

    Ten sources, six with a bit rate of 200 Kbps and four with a bit rate of 400Kbps are to be combined using multi level TDM  with no sync bits. Answer the questions below about the final phase of multiplexing: a

  • Q : What is Refraction law Refraction law:

    Refraction law: For a wave-front travelling via a boundary among two media, the first with a refractive index of n1, and the other with one of n2, the angle of incidence theta is associated to the angle of refraction phi by:

  • Q : Define Photovoltaics Photovoltaics (PV)

    Photovoltaics (PV): It transform light directly into electricity. The typical current residential installation of 12m2 could produce around 1,300 kWh pa with a peak of around 1.9kW, though larger and more efficient installations are possibl

  • Q : What are Woodward-Hoffmann rules

    Woodward-Hoffmann rules: The rules leading the formation of products throughout certain kinds of organic reactions.

  • Q : Explain Casimir effect Casimir effect

    Casimir effect (Casimir): The quantum mechanical effect, where two very big plates positioned close to each other will experience an attractive force, in the nonattendance of other forces. The cause is implicit particle-antiparticle p

  • Q : Nuclear Physics Homework Help NUCLEAR

    NUCLEAR PHYSICS (PHY555) HOMEWORK #1 1. Calculate the luminosity for a beam of protons of 1 µA colliding with a stationary liquid hydrogen target 30 cm long. Compare this to a typical colliding beam luminosity of ∼1034 cm-2