--%>
Assignment Help - homework help

Calculating adiabatic flame temperature

Calculate the adiabatic flame temperature of acetylenes gas at a pressure of 1 bar under the following conditions. The reactants are initially at 298K. Assume that the acetylene reacts completely to form CO2 and H2O:

a. It is combusted in a stoichiometric mixture of O2.
b. It is combusted in a stoichiometric mixture of air.
c. It is combusted with twice the amount of air as needed stoichiometrically.

   Related Questions in Chemical Engineering

  • Q : Materials and energy balance you look

    you look up the specific gravity of 96% H2SO4 and find it is 1.858.calculate the weight

    		•
  • Q : Problem on flow rate of natural gas

    Natural Gas is flowing through a 10 inch schedule 40 pipe. The gas is at 109°F and 7.3 psig. The outside air temperature is 92°F. If the flow rate of the gas is 8,000 SCFM: What is the flow rate in lb/hr?

    		•
  • Q : Problem on Clausius-Clapeyron equation

    The Clausius-Clapeyron equation gives us an expression for dP/dT. Now we will derive an analog to the Clausius-Clapeyron equation by obtaining an expression for dT/dµ when two phases are at equilibrium. For simplicity, let’s derive this fo

    		•
  • Q : Calculating adiabatic flame temperature

    Calculate the adiabatic flame temperature of acetylenes gas at a pressure of 1 bar under the following conditions. The reactants are initially at 298K. Assume that the acetylene reacts completely to form CO2 and H2O:

    Q : Problem on heat of sublimation Using

    Using the vapor pressure data provided below, estimatei) the heat of sublimation of ice,ii) the heat of vaporization of water,iii) the heat of fusion of ice and compare your estimate with the published value of 6010 J/moLiv) the triple point of wate

    		•
  • Q : Problem on weight fraction A gas

    A gas contains 350 ppm of H2S in CO2 at 72°F and 1.53 atm pressure. If the gas is liquified, what is the weight fraction H2S?

    		•
  • Q : Problem on entropy A heater (heat

    A heater (heat source temperature = 527 K) and turbine are connected in series as shown below:

    Q : Temprature To determine the temperature

    To determine the temperature that occurred in a ?re in a warehouse, the arson investigator noticed that the relief valve on a methane storage tank had popped open at 3000 psig, the rated value. Before the ?re started, the tank was presumably at ambient conditions and the gage read 1950 psig. If

    		•
  • Q : Bsc what is the latent heat of

    what is the latent heat of vaporization for hexane

    		•
  • Q : Calculate the pressure Calculate the

    Calculate the pressure at the bottom of a column of Ethanol 100 ft high using a pressure (force) balance in American Engineering Units.

    		•